Fortinet
NSE7 · Question #17
Examine the IPsec configuration shown in the exhibit; then answer the question below. An administrator wants to monitor the VPN by enable the IKE real time debug using these commands: diagnose vpn…
The correct answer is A. The IKE real time debug shows the phases 1 and 2 negotiations only. It does not show any more. See the full explanation below for the reasoning.
Question
Examine the IPsec configuration shown in the exhibit; then answer the question below. An administrator wants to monitor the VPN by enable the IKE real time debug using these commands:
diagnose vpn ike log-filter src-addr4 10.0.10.1 diagnose debug application ike -1 diagnose debug enable The VPN is currently up, there is no traffic crossing the tunnel and DPD packets are being interchanged between both Ipsec gateways. However, the IKE rea time debug does NOT show any output. Why isn't there any output?
Exhibit
Options
- AThe IKE real time debug shows the phases 1 and 2 negotiations only. It does not show any more
- BThe log-filter setting is set incorrectly. The VPN's traffic does not match this filter.
- CThe IKF real time debug shows the phase 1 negotiation only. For information after that, the
- DThe IKE real time debug shows error messages only. If it does not provide any output, it indicates
How the community answered
(47 responses)- A74% (35)
- B4% (2)
- C15% (7)
- D6% (3)
Community Discussion
No community discussion yet for this question.