NSE6_FSW-7.2 Exam Questions
52 real NSE6_FSW-7.2 exam questions with expert-verified answers and explanations. Page 1 of 2.
- Question #1
Refer to the diagnostic output: Two entries in the exhibit show that the same MAC address has been used in two different VLANs. Which MAC address is shown in the above output?
- Question #2
Refer to the exhibit. Core-1 and Access-1 are managed and authorized by FortiGate-1. which uses port4 as the FortiLink interface. After FortiGate authorizes and manages Core-2. Por...
- Question #3
Which two statements about the FortiLink authorization process are true? (Choose two.)
- Question #4
Refer to the exhibits Traffic arriving on port2 on FortiSwitch is tagged with VLAN ID 10 and destined for PC1 connected on port1. PC1 expects to receive traffic untagged from port1...
- Question #5
Refer to the exhibits. Port1 and port2 are the only ports configured with the same native VLAN 10. What are two reasons that can trigger port1 to shut down? (Choose two.)
- Question #6
Refer to the diagnostic output: What makes the use of the sniffer command on the FortiSwitch CLI unreliable on__port__23?
- Question #7
Which interfaces on FortiSwitch send out FortiLink discovery frames by default in order to detect a FortiGate with an enabled FortiLink interface?
- Question #8
Which LLDP-MED Type-Length-Values does FortiSwitch collect from endpoints to track network devices and determine their characteristics?
- Question #9
Refer to the exhibit. What two conclusions can be made regarding DHCP snooping configuration? (Choose two.)
- Question #10
What are two reasons why time synchronization between FortiGate and its managed FortiSwitch is critical in switch management? (Choose two.)
- Question #11
Which statement about the quarantine VLAN on FortiSwitch is true?
- Question #12
Refer to the exhibit. The exhibit shows the current status of the ports on the managed FortiSwitch. Access-1. Why would FortiGate display a serial number in the Native VLAN column...
- Question #13
What are two ways in which automatic MAC address quarantine works on FortiSwitch? (Choose two.)
- Question #14
How does FortiGate handle configuration of flow tracking sampling if you export the settings to a managed FortiSwitch stack with sampling mode set to perimeter is true?
- Question #15
Refer to the exhibit. The profile shown in the exhibit is assigned to a group of managed FortiSwitch ports, and these ports are connected to endpoints which are powered by PoE. Whi...
- Question #16
Which two types of Layer 3 interfaces can participate in dynamic routing on FortiSwitch? (Choose two.)
- Question #17
What feature can network administrators use to segment network operations and the administration of managed FortiSwitch devices on FortiGate?
- Question #18
Which packet capture method allows FortiSwitch to capture traffic on trunks and management interfaces?
- Question #19
Which Ethernet frame can create Layer 2 flooding due to all bytes on the destination MAC address being set to all FF?
- Question #20
Which is a requirement to enable SNMP v2c on a managed FortiSwitch?
- Question #21
What can an administrator do to maintain a FortiGate-compatible FortiSwitch configuration when changing the management mode from standalone to FortiLinK?
- Question #22
Refer to the exhibit. Which two statements best describe what is displayed in the FortiLink debug output shown in the exhibit? (Choose two.)
- Question #23
Which two statements about VLAN assignments on FortiSwitch ports are true? (Choose two.)
- Question #24
Which two rules used by MSTP are similar to rules used by other STP methods? (Choose two.)
- Question #25
Refer to the configuration: Which two conditions does FortiSwitch need to meet to successfully configure the options shown in the exhibit above? (Choose two.)
- Question #26
Which QoS mechanism maps packets with specific CoS or DSCP markings to an egress queue?
- Question #27
Which statement about 802.1X security profiles using MAC-based authentication mode is true?
- Question #28
Refer to the exhibits. You are asked to ensure that managed FortiSwitch devices are reachable by other devices, such as SNMP and other management tools across your network. Which s...
- Question #29
Which drop policy mode, if assigned to a congested port, will drop incoming packets until there is no congestion on the egress port?
- Question #30
How does FortiSwitch perform actions on ingress and egress traffic using the access control list (ACL)?
- Question #31
An administrator needs to deploy managed FortiSwitch devices in a remote location where multiple VLANs must be utilized to segment devices. No Layer 3 switch or router is present....
- Question #32
How are the 'by VLAN redirect MAC address quarantine' mode and the 'by redirect MAC address quarantine' mode on FortiGate similar?
- Question #33
In which two ways can you assign a FortiSwitch port to a VDOM using multi-tenancy setup? (Choose two.)
- Question #34
Which statement about the use of the switch port analyzer (SPAN) packet capture method is true?
- Question #35
What is the role of a device that is simultaneously functioning as both the distribution and core in the hierarchy network model?
- Question #36
Which two statements about DHCP snooping enabled on a FortiSwitch VLAN are true? (Choose two.)
- Question #37
To enhance service in emergency situations, to which LLDP-MED Type-Length-Values does Forti- Switch advertise to IP phones?
- Question #38
Which statement about using MAC, IP, and protocol-based VLANs on FortiSwitch is true?
- Question #39
Which statement about the configuration of VLANs on a managed FortiSwitch port is true?
- Question #40
Which statement about the IGMP snooping querier when enabled on a VLAN is true?
- Question #41
Which feature should you enable to reduce the number or unwanted IGMP reports processed by the IGMP querier?
- Question #42
What type of multimode transceiver can be used to split a 40G port?
- Question #43
Which two statements about 802.1X authentication on FortiSwitch ports are true? (Choose two.)
- Question #44
Which two statements about managing a FortiSwitch stack on FortiGate are true? (Choose two.)
- Question #45
How is traffic routed on FortiSwitch?
- Question #46
Exhibit. Port24 is the only uplink port connected to the network where access to FortiSwitch management services is possible. However, FortiSwitch is still not accessible on the ma...
- Question #47
Exhibit. LAG and MCLAG are used to increase the available network bandwidth and enable redundancy. How does spanning tree protocol see MCLAG and LAG if they are configured based on...
- Question #48
FortiGate is unable to establish a tunnel with the FortiSwitch device it is supposed to manage Based on the debug output shown in the exhibit, what is the reason for the failure?
- Question #49
What can an administrator do to maintain the existing standalone FortlSwltch configuration while changing the management mode to FortLink?
- Question #50
Refer to the exhibit. Two routes are not installed in the forwarding information base (FIB) as shown in the exhibit. Which two statements about these two route entries are true? (C...