Fortinet
NSE6_FSW-7.2 · Question #47
Exhibit. LAG and MCLAG are used to increase the available network bandwidth and enable redundancy. How does spanning tree protocol see MCLAG and LAG if they are configured based on the physical view…
The correct answer is C. Switch 3 and switch 4 are seen as one MCLAG switch client D. Switch 1 and Switch 2 both seen as one single switch. See the full explanation below for the reasoning.
Question
Exhibit. LAG and MCLAG are used to increase the available network bandwidth and enable redundancy. How does spanning tree protocol see MCLAG and LAG if they are configured based on the physical view shown in the exhibit? (Choose two)
Exhibit
Options
- ASwitch 1. Switch 2, and Switch 3 are seen as one MCLAG peer group
- BSwitch 3 and Switch 4 uplinks are treated as single interfaces.
- CSwitch 3 and switch 4 are seen as one MCLAG switch client
- DSwitch 1 and Switch 2 both seen as one single switch.
How the community answered
(16 responses)- A25% (4)
- B6% (1)
- C69% (11)
Community Discussion
No community discussion yet for this question.