NS0-158 · Question #70
Which commands can be used to create a data Vserver? (choose all that apply)
The correct answer is B. vserver setup E. vserver create. To create a data Vserver in NetApp ONTAP, administrators can use either the interactive vserver setup command or the direct vserver create command.
Question
Which commands can be used to create a data Vserver? (choose all that apply)
Options
- Avserver configure
- Bvserver setup
- Cvserver set_up
- Dvserver make
- Evserver create
How the community answered
(23 responses)- B91% (21)
- C4% (1)
- D4% (1)
Why each option
To create a data Vserver in NetApp ONTAP, administrators can use either the interactive `vserver setup` command or the direct `vserver create` command.
`vserver configure` is not a valid command for the initial creation of Vservers; configuration typically follows creation.
The `vserver setup` command provides an interactive wizard to guide administrators through the necessary steps for creating and configuring a new Vserver.
`vserver set_up` is an invalid command syntax and does not exist for creating Vservers in ONTAP.
`vserver make` is not a valid or recognized command for creating Vservers in ONTAP.
The `vserver create` command allows for direct, non-interactive creation of a Vserver by specifying all required parameters upfront in the command line.
Concept tested: ONTAP Vserver creation commands
Source: https://docs.netapp.com/us-en/ontap/vservers/create-vserver-using-create-command-task.html
Topics
Community Discussion
No community discussion yet for this question.