Nutanix
NCM-MCI-5.20 · Question #85
An administrator recently added in 3 nodes to an existing 5 node cluster. While 1 node came with its own block, the other 2 nodes where added to an existing share. After adding the nodes, the…
The correct answer is D. Check the factory_config. json for the two single nodes. See the full explanation below for the reasoning.
Question
An administrator recently added in 3 nodes to an existing 5 node cluster. While 1 node came with its own block, the other 2 nodes where added to an existing share. After adding the nodes, the administrator sees that the hardware tab displays the correct number of nodes, but incorrect position in the diagram tab. What should the administrator do to resolve the issue?
Options
- ACheck the factory_config.json for all 3 nodes
- BSSH into CVM and perform genesis restart on each CVM
- CSSH into the CVMs and run genesis acropolis stop; cluster start
- DCheck the factory_config. json for the two single nodes.
How the community answered
(22 responses)- A9% (2)
- B5% (1)
- C5% (1)
- D82% (18)
Community Discussion
No community discussion yet for this question.