You need to ensure that the picking workbench suggests which boxes to use to package picked items. Which two configurations should you perform? Each correct answer presents part of the solution.

Question

Options

• AFrom the Inventory and warehouse management parameters form, select Boxing logic for
• BLink boxing definitions to each item before you run the picking workbench.
• CFrom the Released products form, select Apply boxing logic for picking work bench for each
• DCreate a new workbench profile and apply the profile when you run the picking workbench.

• A
  78% (18)
• B
  13% (3)
• D
  9% (2)

Explanation

Boxing logic is a part of the process of releasing items for picking and grouping items on a picking route. If an item requires packaging, then boxing logic can help determine the smallest box for the items to most efficiently fit into. Boxing logic is designed to select a suitably-sized box, and optimize the maximum capacity of that box, for the set of items on a picking route. To enable boxing logic, follow these steps: Click Inventory management > Setup > Inventory and warehouse management parameters. (A)On the General tab, in the Boxing logic group, select the Boxing logic for picking workbench Click Inventory management > Setup > Boxing logic > Box definitions. Select the Active check box to enable the box definition. Click Product information management > Common > Released products. Select a product. Click Edit. (C)On the Deliver FastTab, select the Apply boxing logic for picking work bench check box.

No community discussion yet for this question.