Refer to the exhibit. In a newly configured VPLS network, you see the output shown in the exhibit. The remote PE is 10.1.1.2. What is the cause for the OL status?

Question

Exhibits

Options

• AThere is not a proper label-switched path to the remote PE, so there is no MPLS path to the
• BThe VPLS site identifiers are not contiguous, causing label block allocation to run out of labels.
• CThe MPLS protocol family is not configured for interface fe-0/1/2.2, so the LDP adjacency is in an
• DThe remote PE is using the wrong route distinguisher, so the outgoing labels are incorrect.

• A
  10% (4)
• B
  85% (33)
• C
  3% (1)
• D
  3% (1)

No community discussion yet for this question.