Juniper
JN0-643 · Question #287
You have certainly implemented the configuration shown in the exhibit. After committing these changes, the community devices connected to AS-1 are not able to communicate with the appropriate…
The correct answer is D. You must configure the ge-0/012 interface on both switches as P VLAN trunks. See the full explanation below for the reasoning.
Question
You have certainly implemented the configuration shown in the exhibit. After committing these changes, the community devices connected to AS-1 are not able to communicate with the appropriate community devices connected to AS-2. What must be done to allow these community devices to communicate?
Exhibit
Options
- AYou must configure an isolation VLAN ID Under the pvlan-200 on the AS2
- Bswitch You must configure the ge-0/0/10 interface on AS1 AS THE VPLAN on both switches
- CYou must configure an isolation VLAN ID under the VLAN 200 ON both switches
- DYou must configure the ge-0/012 interface on both switches as P VLAN trunks
How the community answered
(48 responses)- A8% (4)
- B15% (7)
- C4% (2)
- D73% (35)
Community Discussion
No community discussion yet for this question.