Juniper
JN0-643 · Question #243
You have certainly implemented the configuration shown in the exhibit. After committing these changes, the community devices connected to AS1 are not able to communicate with the appropriate…
The correct answer is D. You must configure the ge 0/012 interface on both switches as pvlan trunks. See the full explanation below for the reasoning.
Question
You have certainly implemented the configuration shown in the exhibit. After committing these changes, the community devices connected to AS1 are not able to communicate with the appropriate community devices connected to AS2. What must be done to allow these community devices to communicate?
Options
- AYou must configure an isolation VLAN ID under the pvlan 200 on the AS 2 switch
- BYou must configure the ge 0/0/10 interface as AS1 as the pvlan trunk
- CYou must configure an isolation VLAN ID under the pvlan 200 on both the switches
- DYou must configure the ge 0/012 interface on both switches as pvlan trunks
How the community answered
(47 responses)- A4% (2)
- B2% (1)
- C11% (5)
- D83% (39)
Community Discussion
No community discussion yet for this question.