Juniper
JN0-643 · Question #187
You are implementing Q-in-Q tunneling to connect R1 and R2 using the configurations shown in the exhibit. What must be changed on Switch_A to allow both Dot1q-tunneling VLANs and non- Dot1q…
The correct answer is C. Change the Dot1q-tunneling Ethertype to 0x8100. See the full explanation below for the reasoning.
Question
You are implementing Q-in-Q tunneling to connect R1 and R2 using the configurations shown in the exhibit. What must be changed on Switch_A to allow both Dot1q-tunneling VLANs and non- Dot1q- tunneling VLANs on the same trunk interface?
Exhibit
Options
- AChange the Dot1q-tunneling Ethertype to 0x9100.
- BChange the Dot1q-tunneling Ethertype to 0x88a8.
- CChange the Dot1q-tunneling Ethertype to 0x8100.
- DChange the Dot1q-tunneling Ethertype to 0x98a8.
How the community answered
(61 responses)- A8% (5)
- B16% (10)
- C72% (44)
- D3% (2)
Community Discussion
No community discussion yet for this question.