Juniper
JN0-643 · Question #179
You want to control bursts of HTTP traffic entering your SRX Series Gateway. To support varying requirements, interfaces ge-0/0/0 through ge-0/0/3 should each be rate-limited separately, using the…
The correct answer is C. Configure a policer and reference it in a firewall filter that uses the interface-specific option; apply. See the full explanation below for the reasoning.
Question
You want to control bursts of HTTP traffic entering your SRX Series Gateway. To support varying requirements, interfaces ge-0/0/0 through ge-0/0/3 should each be rate-limited separately, using the same parameters. What is the correct way to meet these requirements?
Options
- AConfigure a single policer and apply it directly on the appropriate interfaces.
- BConfigure four policers and apply each one directly on the appropriate interface.
- CConfigure a policer and reference it in a firewall filter that uses the interface-specific option; apply
- DConfigure four policers and reference them all in a firewall filter; apply the filter to the appropriate
How the community answered
(41 responses)- A15% (6)
- B5% (2)
- C73% (30)
- D7% (3)
Community Discussion
No community discussion yet for this question.