Your company is integrating another OSPF area into your existing OSPF infrastructure. You created a virtual link that spans Area 2 and connects Area 3 to the backbone area. {master:0}[edit] user@router# run show ospf interface vl-10.20.10.2 extensive Interface State Area DR ID BDR ID Nbrs vl-10.20.10.2 Down 0.0.0.0 0.0.0.0 0.0.0.0 0 TypE. Virtual, Address: 0.0.0.0, Mask: 0.0.0.0, MTU: 0, Cost: 1 Transit AreA. 0.0.0.1 Adj count: 0 Hello: 10, DeaD. 40, ReXmit: 5, Not Stub Auth typE. None Protection typE. None, No eligible backup Topology default (ID 0) - Down, Cost: 0 Based on the exhibit, what is preventing the adjacency?

Question

Your company is integrating another OSPF area into your existing OSPF infrastructure. You created a virtual link that spans Area 2 and connects Area 3 to the backbone area. {master:0}[edit] user@router# run show ospf interface vl-10.20.10.2 extensive Interface State Area DR ID BDR ID Nbrs vl-10.20.10.2 Down 0.0.0.0 0.0.0.0 0.0.0.0 0 TypE. Virtual, Address: 0.0.0.0, Mask: 0.0.0.0, MTU: 0, Cost: 1 Transit AreA. 0.0.0.1 Adj count: 0 Hello: 10, DeaD. 40, ReXmit: 5, Not Stub Auth typE. None Protection typE. None, No eligible backup Topology default (ID 0) -> Down, Cost: 0 Based on the exhibit, what is preventing the adjacency?

Accepted Answer

D. The wrong transit area is configured.

Answer

A. The interface configured for the virtual link is incorrect. It should be a vt and not a vl interface.

Answer

B. No designated router (DR) has been elected.

Answer

C. The backup route to Area 2 has not been configured.

Your company is integrating another OSPF area into your existing OSPF infrastructure. You created a virtual link that spans Area 2 and connects Area 3 to the backbone area. {master:0}[edit]…

Question

Options

How the community answered

Community Discussion