JN0-643 · Question #152
The CLI output shown in the exhibit was taken from the RP in a PIM-SM network. Which statement explains the output shown in the exhibit? user@RP> show pim join extensive InstancE. PIM.master Family…
The correct answer is D. The router does not have a unicast route to 10.0.5.2. See the full explanation below for the reasoning.
Question
The CLI output shown in the exhibit was taken from the RP in a PIM-SM network. Which statement explains the output shown in the exhibit? user@RP> show pim join extensive InstancE. PIM.master Family: INET R = Rendezvous Point Tree, S = Sparse, W = Wildcard Group: 224.1.1.1 SourcE. * RP: 192.168.1.1 Flags: sparse,rptree,wildcard Upstream interfacE. Local Upstream neighbor: Local Upstream statE. Local RP Downstream neighbors:
InterfacE. so-0/0/0.0 10.0.1.2 StatE. Join Flags: SRW Timeout: 176 Group: 224.1.1.1 SourcE. 10.0.5.2 Flags: sparse,spt Upstream interfacE. unknown (no nexthop) Upstream neighbor: unknown Upstream statE. Local RP Keepalive timeout: 106 Downstream neighbors:
InterfacE. so-0/0/0.0 10.0.1.2 StatE. Join Flags: S Timeout: 176 InstancE. PIM.master Family: INET6 R = Rendezvous Point Tree, S = Sparse, W = Wildcard
Options
- ANo tunnel PIC is installed on the RP router.
- B192.168.1.1 is not a local IP address on the RP router.
- CMulticast traffic is arriving on the so-0/0/0.0 interface.
- DThe router does not have a unicast route to 10.0.5.2.
How the community answered
(41 responses)- A2% (1)
- B10% (4)
- C5% (2)
- D83% (34)
Community Discussion
No community discussion yet for this question.