Juniper
JN0-533 · Question #16
You must verify on your ScreenOS device that you have configured the correct tunnel peer and determine which IKE proposals the remote device is sending and accepting. Which command should you use?
The correct answer is A. get ike gateway. See the full explanation below for the reasoning.
Question
You must verify on your ScreenOS device that you have configured the correct tunnel peer and determine which IKE proposals the remote device is sending and accepting. Which command should you use?
Options
- Aget ike gateway
- Bget ike peer
- Cget sa active
- Dget ike active
How the community answered
(48 responses)- A71% (34)
- B8% (4)
- C17% (8)
- D4% (2)
Community Discussion
No community discussion yet for this question.