Juniper
JN0-533 · Question #4
You are troubleshooting telnet traffic destined to IP address 10.10.10.1. You decide to run debug and want to set the flow filter. Which command will show only the telnet traffic going to the…
The correct answer is B. ssg5-serial-> set ffilter dst-ip 10.10.10.1 dst-port 23. See the full explanation below for the reasoning.
Question
You are troubleshooting telnet traffic destined to IP address 10.10.10.1. You decide to run debug and want to set the flow filter. Which command will show only the telnet traffic going to the 10.10.10.1 address?
Options
- Assg5-serial-> set ffilter dst-ip 10.10.10.1
- Bssg5-serial-> set ffilter dst-ip 10.10.10.1 dst-port 23
- Cssg5-serial-> set ffilter dst-port 23
- Dssg5-serial-> set ffilter dst-ip 10.10.10.1
How the community answered
(37 responses)- A5% (2)
- B81% (30)
- C3% (1)
- D11% (4)
Community Discussion
No community discussion yet for this question.