JN0-362 Exam Questions

An Ethernet bridge is configured such that all interfaces are in a single broadcast domain By default. Which two tasks does the bridge perform in response to receiving a multicast...

Which configuration can be applied to ensure that no more than 600 MAC addresses are learned by a virtual switch?

You are logged into a PE router participating in a Layer 3 VPN as defined in RFC 4364. You would like to ping the remotely connected CE router's loopback address. The address of th...

Click the Exhibit button. You have two routers connected over a Gigabit Ethernet link as shown in the exhibit It is required that an IS-IS adjacency be established without the need...

Which two problems occur when increasing numbers of users are added to an Ethernet LAN with no switches present? (Choose two.)

Click the Exhibit button. In the exhibit, all routers are sending routes to Router B Which routes will be advertised from Router B to Router D?

Click the Exhibit button. Given the OSPF network topology shown in the exhibit, you would like to inject external (non- OSPF) routes into the network on Router D Which two OSPF are...

By default, which RSVP reservation style is used by the Junos OS?

Which three statements are true about BGP? (Choose three)

You observe that VPN routes are hidden on your PE router Which situation accounts for these hidden routes?

To prevent fragmentation issues across a GRE tunnel, which MTU value is recommended for the tunnel to accommodate most IP packets?

By default, which three criteria are used by the Junos load-balancing algorithm to determine a traffic flow? (Choose three.)

Referring to the exhibit, which firewall filter action(s) will be applied to incoming frames to ge-1/0/3?

Click the Exhibit button. In the exhibit, three IPv6 addresses are listed. Which two statements are true? (Choose two.)

You have just configured IPv6 in your network. A packet arrives on your router that exceeds the MTU size. How will an IPv6 router respond?

Which two statements reflect benefits of performing per-flow load balancing over per-packet load balancing? (Choose two.)

By default, the Junos OS advertises which address(es) in LDP forwarding equivalency class (FEC) messages?

Click the Exhibit button. Two bridge domains are configured as shown in the exhibit. What must be configured as part of the ge-1/0/3 interface configuration to accept tagged frames...

What are three valid BGP message types? (Choose three.)

Router A receives two similar route advertisements from different BGP peers.What would cause a route to be selected in this scenario?

Which two configuration elements must match on all switches participating in the same MSTP region? (Choose two.)

Click the Exhibit button. What does IS-IS/18 mean in the output displayed in the exhibit?

What are two characteristics of a traditional Ethernet LAN? (Choose two.)

You are logged into a PE router participating in a Layer 3 VPN as defined in RFC 4364. You would like to ping the locally connected CE router's interface. The address of the interf...

Before configuring an RSVP LSP in your network, you first apply a baseline configuration to all of the routers.Which three configuration elements are minimally required in the base...

Your customer complains that their Layer 3 VPN is not passing traffic from one site to another. You assigned that customer to VPN-A. Which command on the PE router will confirm the...

In an IS-IS network, which device represents the pseudo-node?

Router B is an OSPF router connected to both Area 0 and Area 2. Area 2 has been configured as a totally stubby area.Which three LSA types does Router B suppress from Area 2? (Choos...

What is the size of the unique address used to identify each node on an Ethernet LAN?

You notice that a route from internal BGP peer 192.168.1.1 is missing from the local route table.Which two commands would be used to help identify the source of the problem? (Choos...

What are three ways to configure IPv6 addresses in your network? (Choose three.)

Click the Exhibit button. Which two topologies shown in the exhibit could be implemented without a spanning-tree protocol? (Choose two.)

Click the Exhibit button. In the exhibit, all routers are sending routes to Router B.Which routes will be advertised from Router B to Router E?

In your RSVP network you have configured three separate LSPs to the same egress address. You have made no other configuration changes to the forwarding decisions made by the router...

Which two values are used by an RSTP bridge to remove stale BPDU information? (Choose two.)

Click the Exhibit button. After the MAC learning limit of 3000 is reached for the bd bridge domain as shown in the exhibit, what happens to frames that arrive that contain unknown...

Which two statements are correct regarding TLVs in IS-IS? (Choose two.)

Click the Exhibit. Referring to the exhibit, which route(s) will be exported to neighbor 192.168.1.2?

Click the Exhibit. You have configured the IBGP group shown in the exhibit. However, committing your configuration fails. Which parameter should you add to the IBGP group configura...

What are two methods for decreasing the size of an OSPF link-state database (LSDB)? (Choose two.)

You are setting up a new IS-IS adjacency between two devices. The new Level1 adjacency is not establishing. What would cause this behavior?

Because of recent network failures, additional circuits have been purchased. In addition, Fast reroute has been configured on critical MPLS LSPs. When the next failure occurs, whic...

Click the Exhibit. Referring to the configuration shown in the exhibit, which statement is true?

Click the Exhibit. Referring to the configuration in the exhibit, which two statements are true? (Choose two.)

Click the Exhibit. Referring to the exhibit, R-1 and R-2 are connected with a LAG on the ae0 interface. However, the LAG is not operational. Which action will solve this problem?

Which two Layer 2 protocols are supported on MX Series devices? (Choose two.)

Click the exhibit. In the exhibit, which two routers will perform a swap action on LSP1? (Choose two.)

Click the Exhibit. Your network consists of subnets shown in the exhibit. You are asked to create an aggregate route for Router 1.

What must be configured for all IBGP speakers in an AS to have consistent routing information?

What are two benefits of using an OSPF designated router (DR)? (Choose two.)