JN0-351 Exam Questions
145 real JN0-351 exam questions with expert-verified answers and explanations. Page 3 of 3.
- Question #103
Your switches are managed using Junos Space Network Director. You want to secure the switches using a Network Director filter profile. A filter profile containing one term shown in...
- Question #104
Which two elements are used to create the STP bridge ID? (Choose two.)
- Question #105
Referring to the exhibit, why is the route for 10.5.5.5 hidden?
- Question #106
You want to redistribute the static routes into BGP, but they do not show as BGP routes. What causes this result to occur?
- Question #107
Which two statements are correct about link aggregation? (Choose two.)
- Question #108
Which two statements about MACsec are true? (Choose two.)
- Question #109
You are combining two existing interfaces into a single LAG interface, but you do not see the LAG interface being created. Which two actions are required to solve this problem? (Ch...
- Question #110
You enable persistent MAC learning on your Juniper switch. In this scenario, which statement is correct?
- Question #111
You are deploying a trunk port with multiple VLANs. In this scenario, which statement is true about the native VLAN?
- Question #112
In addition to the MAC addresses, what information is stored in the bridging table? (Choose two.)
- Question #113
When trying to commit the configuration shown in the exhibit, you receive an error. What is the problem?
- Question #114
Which three actions are required for filter-based forwarding? (Choose three.)
- Question #115
Which two statements about the firewall filter terms shown in the exhibit are true? (Choose two.)
- Question #116
You are deploying an EX Series switch with a Wi-Fi access point. The access point needs all untagged traffic to use a specific VLAN. In this scenario, which feature should you enab...
- Question #117
You are asked to explore adding BGP route reflectors to allow for increased scale in your core network. Which statement is correct in this scenario?
- Question #118
Which two statements about BGP facilitate the prevention of routing loops within an autonomous system? (Choose two.)
- Question #119
Your network has two ISPs available. You want to ensure that all outbound traffic is routed out ISP-1. If the connection to ISP-1 fails, all outbound traffic is routed to the backu...
- Question #120
Which three statements are correct about OSPF packet types? (Choose three.)
- Question #121
In a LAN segment, which tie-breaker would spanning tree consider if equal-cost paths exist between two or more switches to the root bridge?
- Question #122
You have two OSPF routers that will not form an adjacency. You enter the show log trace- ospf command. Referring to the exhibit, which statement is correct?
- Question #123
Which statement about the default action of MAC limiting is true when the number of MAC addresses has hit the limit set?
- Question #124
Which statement is correct about the exhibit?
- Question #125
A host is connected to your EX Series switch using an interface with persistent MAC learning enabled. When you connect the host to another interface on the same switch, all traffic...
- Question #126
You are asked to change the setting for the LSAs age out back to the default value. In this scenario, which time interval will accomplish this task?
- Question #127
R1 has a BGP session with a router that has a peer autonomous system number of 64501. It is exchanging routes, and is advertising those routes to IBGP peers. The downstream IBGP pe...
- Question #128
Which statement is correct about the configuration shown in the exhibit?
- Question #129
R1 was started at 4:00 PM. R2 and R3 were started at 6:00 PM. R4 was started at 10:00 PM. All routers are in Area 0 and there are no point-to-point links. Referring to the exhibit,...
- Question #130
Which statement concerning Bidirectional Forwarding Detection (BFD) is true for the configuration shown in the exhibit?
- Question #131
Referring to the exhibit, which three statements are correct? (Choose three.)
- Question #132
You are asked to explore deploying IS-IS in your network. What are two considerations in this scenario? (Choose two.)
- Question #133
Which statement is correct about GRE tunnels?
- Question #134
You are using tunnels in your network. It is important that the routes be specific enough to ensure that the tunnels are established. You need to prevent a route that is new to the...
- Question #135
What are two purposes of an aggregate route? (Choose two.)
- Question #136
You have configured a GRE interface, but no traffic will flow. Referring to the exhibit, which statement is true?
- Question #137
You are configuring a router as a new Level 1 router in an existing Level 1 area. The NET address for an existing Level 1 router is 49.0011.1111.2222.3333.00. The new router must f...
- Question #138
Which two actions are performed by the firewall filter shown in the exhibit? (Choose two.)
- Question #139
Which two multicast IP addresses are used for link-state update packets? (Choose two.)
- Question #140
Your GRE tunnel is not transitioning to the Up status. What would be the first step in troubleshooting the problem?
- Question #141
Which two statements are correct about IS-IS? (Choose two.)
- Question #142
You are asked to create a default route that will be advertised to your internal OSPF neighbors. You have three upstream connections to the Internet and you must ensure that when a...
- Question #143
What is the default hello interval on an OSPF interface?
- Question #144
Which two statements are correct about martian routes? (Choose two.)
- Question #145
You are asked to configure a redundant trunk group (RTG). Which two requirements would accomplish this task? (Choose two.)
- Question #146
Which command solves the error that you see in the exhibit?
- Question #147
Which two statements are correct about VRRP? (Choose two.)