Juniper
JN0-343 · Question #235
Click the Exhibit button. Devices S1 and S2 have the interface configurations as shown in the exhibit. You attach ge-0/0/0 on S1 to ge-0/0/0 on S2. You attach ge-0/0/1 on S1 to ge-1/0/20 on S2…
The correct answer is C. You should configure at least one switch to run LACP in active mode. See the full explanation below for the reasoning.
Question
Click the Exhibit button. Devices S1 and S2 have the interface configurations as shown in the exhibit. You attach ge-0/0/0 on S1 to ge-0/0/0 on S2. You attach ge-0/0/1 on S1 to ge-1/0/20 on S2. However, the ae0 interface remains down on both S1 and S2. What should you change to cause the ae0 interface to come up?
Exhibit
Options
- AYou should use consecutive interfaces on S2.
- BYou should use interfaces on S2 that are on the same member of the Virtual Chassis.
- CYou should configure at least one switch to run LACP in active mode.
- DYou should make the list of VLANs on the ae0 interfaces on S1 and S2 match.
How the community answered
(14 responses)- B7% (1)
- C86% (12)
- D7% (1)
Community Discussion
No community discussion yet for this question.