Juniper
JN0-343 · Question #234
You have created an IP-IP tunnel which will traverse interface at-0/1/0 and you would like to make sure that the tunnel is operational. Which operational-mode command should you use to verify that…
The correct answer is C. show interfaces ip-0/0/0 terse. See the full explanation below for the reasoning.
Question
You have created an IP-IP tunnel which will traverse interface at-0/1/0 and you would like to make sure that the tunnel is operational. Which operational-mode command should you use to verify that the IP-IP tunnel interface is up?
Options
- Ashow ip tunnels interfaces
- Bshow interfaces at-0/1/0 terse
- Cshow interfaces ip-0/0/0 terse
- Dshow ip-0/0/0 interfaces terse
How the community answered
(19 responses)- A16% (3)
- B5% (1)
- C74% (14)
- D5% (1)
Community Discussion
No community discussion yet for this question.