HPE7-A08 · Question #161
You have applied the following OSPF configuration but are not seeing any output from the command below. What is the reason for this?
The correct answer is D. A different OSPF process ID is used on each switch. Each switch is running OSPF under the same VRF but using different OSPF process IDs (Agg-1 uses process 1, Agg-2 uses process 2). On Aruba CX, OSPF adjacencies only form between routers using the same OSPF process ID within the same VRF, so the devices never establish a…
Question
You have applied the following OSPF configuration but are not seeing any output from the command below. What is the reason for this?
Exhibits
Options
- AA loopback interface hasn't been configured on Agg-2.
- BA VRF wasn't specified in the show command.
- COSPF interfaces are passive by default.
- DA different OSPF process ID is used on each switch.
How the community answered
(67 responses)- A13% (9)
- B6% (4)
- C25% (17)
- D55% (37)
Explanation
Each switch is running OSPF under the same VRF but using different OSPF process IDs (Agg-1 uses process 1, Agg-2 uses process 2). On Aruba CX, OSPF adjacencies only form between routers using the same OSPF process ID within the same VRF, so the devices never establish a neighbor relationship.
Topics
Community Discussion
No community discussion yet for this question.