HPE7-A07 · Question #40

HPE7-A07 Question #40: Real Exam Question with Answer & Explanation

The correct answer is C. Both switches are configured as VRRP 'primary.'. In VRRP (Virtual Router Redundancy Protocol), only one switch should be the primary (master) for a given virtual IP address, with the other switches being backups. If both switches are showing as active, it suggests a misconfiguration where both are set to act as the primary for

Question

Refer to the exhibit. After configuring VRRP between SW-1 and SW-2, you notice that both switches are showing as active. What could be the reason for this issue?

Exhibit

Options

AVRRP preemptive mode is disabled.
BSW-1 cam reach SW-2 on VLAN 10.
CBoth switches are configured as VRRP 'primary.'
DSW-2 has no priority configurations for VRRP 1.

Explanation

In VRRP (Virtual Router Redundancy Protocol), only one switch should be the primary (master) for a given virtual IP address, with the other switches being backups. If both switches are showing as active, it suggests a misconfiguration where both are set to act as the primary for the same VRRP group. The exhibits provided indicate that both switches believe they are the active or primary for the VRRP group, which is an incorrect configuration.

Community Discussion

No community discussion yet for this question.

Full HPE7-A07 Practice