HPE7-A01 Exam Questions

What is an OSPF transit network?

Your Aruba CX 6300 VSF stack has OSPF adjacency over SVI 10 with LAG 1 to a neighboring device. The following configuration was created on the switch: A. B. C. D.

What is an Aruba-recommended best practice for hardening that only applies to Aruba CX 6300 series switches with dedicated management ports?

A customer is using stacked Aruba CX 6200 and CX 6300 switches for access and a VSX pair of Aruba CX 8325 as a collapsed core 802.1X is implemented for authentication. Due to the l...

Which feature supported by SNMPv3 provides an advantage over SNMPv2c?

You are configuring Policy Based Routing (PBR) for a subnet that will be used to test a new default route for your network Traffic originating from 10.2.250.0/24 should use a new d...

Two AOS-CX switches are configured with VSX at the the Access-Aggregation layer where servers attach to them An SVI interface is configured for VLAN 10 and serves as the default ga...

Which Aruba AP mode is sending captured RF data to Aruba Central for waterfall plot?

You need to create a keepalive network between two Aruba CX 8325 switches for VSX configuration How should you establish the keepalive connection?

Which method is used to onboard a new UXI in an existing environment with 802.1X authentication? (The sensor has no cellular connection)

How is Multicast Transmission Optimization implemented in an HPE Aruba wireless network?

The customer needs a network hardware refresh to replace an aging Aruba 5406R core switch pair using spanning tree configuration with Aruba CX 8360-32YC switches. What is the benef...

What is enabled by LLDP-MED? (Select two.)

A company deployed Dynamic Segmentation with their CX switches and Gateways After performing a security audit on their network, they discovered that the tunnels built between the C...

You need lo have different routing-table requirements with Aruba CX 6300 VSF configuration. Assuming the correct layer-2 VLAN already exists, how would you create a new OSPF config...

A customer has a large number of food-producing machines: - All machines are connected via Aruba CX6200 switches in VLANs 100.110. and 120 - Several external technicians are mainta...

In an ArubaOS 10 architecture using an AP and a gateway, what happens when a client attempts to join the network and the WLAN is configured with OWE?

Describe the difference between Class of Service (CoS) and Differentiated Services Code Point (DSCP).

A customer is using a legacy application that communicates at layer-2. The customer would like to keep this application working across the campus which is connected via layer-3. Th...

A network engineer recently identified that a wired device connected to a CX Switch is misbehaving on the network To address this issue, a new ClearPass policy has been put in plac...

You are doing tests in your lab and with the following equipment specifications: * AP1 has a radio that generates a 10 dBm signal * AP2 has a radio that generates a 11 dBm signal *...

A system engineer needs to preconfigure several Aruba CX 6300 switches that will be sent to a remote office. An untrained local field technician will do the rollout of the switches...

In AOS 10, which session-based ACL below will only allow ping from any wired station to wireless clients but will not allow ping from wireless clients to wired stations?

A new network design is being considered to minimize client latency in a high-density environment. The design needs to do this by eliminating contention overhead by dedicating subc...

What is a primary benefit of BSS coloring?

Your manufacturing client is having installers deploy seventy headless scanners and fifty IP cameras in their warehouse These new devices do not support 802 1X authentication. How...

When setting up an Aruba CX VSX pair, which information does the Inter-Switch Link Protocol configuration use in the configuration created?

Review the exhibit. You are troubleshooting an issue with a 10.102.39 0/24 subnet which is also VLAN 1000 used Tor wireless clients on a pair of Aruba CX 8360 switches The subnet S...

What is true regarding 802.11k?

The administrator notices that wired guest users that have exceeded their bandwidth limit are not being disconnected Access Tracker in ClearPass indicates a disconnect CoA message...

You are helping an onsite network technician bring up an Aruba 9004 gateway with ZTP for a branch office The technician was to plug in any port for the ZTP process to start Thirty...

Your Director of Security asks you to assign AOS-CX switch management roles to new employees based on their specific job requirements. After the configuration was complete, it was...

A company recently deployed new Aruba Access Points at different branch offices Wireless 802.1X authentication will be against a RADIUS server in the cloud. The security team is co...

You are deploying a bonded 40 MHz wide channel. What is the difference in the noise floor perceived by a client using this bonded channel as compared to an unbonded 20MHz wide chan...

Using Aruba best practices what should be enabled for visitor networks where encryption is needed but authentication is not required?

Describe the difference between Class of Service (CoS) and Differentiated Services Code Point (DSCP).

You are configuring an SVI on an Aruba CX switch that needs to have the following characteristics: * VLANID = 25 * IPv4 address 10 105 43 1 with mask 255.255.255.0 * IPv6 address f...

Due to a shipping error, five (5) Aruba AP-515S and one (1) Aruba CX 6300 were sent directly to your new branch office. You have configured a new group persona for the new branch o...

What steps are part of the Key Management workflow when a wireless device is roaming from AP1 to AP2? (Select two.)

Which statement best describes QoS?

A customer wants to enable wired authentication across all their CX switches. One of the requirements is that the switch must be able to authenticate a single computer connected th...

Refer to the exhibit. A company has deployed 200 AP-635 access points. To but is not working as expected. What would be the correct action to fix the issue?

A network administrator is troubleshooting some issues guest users are having when connecting and authenticating to the network. The access switches are AOS-CX switches. What comma...

A network administrator is attempting to troubleshoot a connectivity issue between a group of users and a particular server. The administrator needs to examine the packets over a p...

On AOS10 Gateways, which device persona is only available when configuring a Gateway-only group?

What is the best practice for handling voice traffic with dynamic segmentation on AOS-CX switches?

A customer is using Aruba Cloud Guest, but visitors keep complaining that the captive portal page keeps coming up after devices go to sleep. Which solution should be enabled to dea...

With the Aruba CX switch configuration, what is the first-hop protocol feature that is used for VSX L3 gateway as per Aruba recommendation?

Which method is used to onboard a new UXI in an existing environment with 802.1X authentication? (The sensor has no cellular connection)

You are setting up a customer's 15 headless loT devices that do not support 802.1X.. What should you use?