(Scenarios may contain multiple errors, which may or may not impact the solution.) Refer to the exhibit. An engineer has attempted to configure two pairs of switches in the referenced configuration. It is required to implement VSX at the aggregation layer. The ports of the Aruba-CX 8325 switches used for Agg01 and Agg02 are populated as follows:

The VSX cluster is not forming. Which modification should you make to resolve the error condition?

Question

(Scenarios may contain multiple errors, which may or may not impact the solution.) Refer to the exhibit. An engineer has attempted to configure two pairs of switches in the referenced configuration. It is required to implement VSX at the aggregation layer. The ports of the Aruba-CX 8325 switches used for Agg01 and Agg02 are populated as follows:

The VSX cluster is not forming. Which modification should you make to resolve the error condition?

Accepted Answer

D. Edit the vsx-sync command, adding "keep-alive"

Answer

A. Modify the keepalive peer 192.168.20.2 source 192.168.20.1 command, changing "vrf KA" to "vrf

Answer

B. Modify the vsx definition, changing "inter-switch-link lag 2" to "inter-switch-link lag 256"

Answer

C. Modify the system interface-group 4 speed 10g command, change "25g" to "10g"

(Scenarios may contain multiple errors, which may or may not impact the solution.) Refer to the exhibit. An engineer has attempted to configure two pairs of switches in the referenced configuration…

Question

Exhibits

Options

How the community answered

Community Discussion