HP
HPE6-A45 · Question #140
Switch-2 and Switch-3 lost IP connectivity with each other. They did not detect the issue for several seconds and caused a temporary traffic disruption. The administrator implemented BFD for link…
The correct answer is D. Set a BFD source IP address on each OSPF routing switch in VLAN 100. See the full explanation below for the reasoning.
Question
Switch-2 and Switch-3 lost IP connectivity with each other. They did not detect the issue for several seconds and caused a temporary traffic disruption. The administrator implemented BFD for link backup paths through Switch-3 to occur in one than a second. The administrations verified the failed link and view the output on Switch-1, shown in the exhibit. What should they do to create the expected behavior if connectivity is lost again?
Options
- ALower the hello timer to a given range of time on each OSPF routing switch in VLAN 100
- BEnable BFD for the multicast routing node on OSPF routing switch in VLAN 100
- CManually configure the network type as point-to-point on each OSPF routing switch in VLAN 100
- DSet a BFD source IP address on each OSPF routing switch in VLAN 100
How the community answered
(28 responses)- A4% (1)
- B4% (1)
- C14% (4)
- D79% (22)
Community Discussion
No community discussion yet for this question.