HP
HPE6-A45 · Question #127
OSPF is configured on an AOS-Switch, and the network administrator sets the router ID to 10.0.0.1. The administrator wants to be able to reach the switch at this IP address, and to participate in…
The correct answer is D. Configure 10.0.0.1 on a loopback interface and enable OSPF on that interface. See the full explanation below for the reasoning.
Question
OSPF is configured on an AOS-Switch, and the network administrator sets the router ID to 10.0.0.1. The administrator wants to be able to reach the switch at this IP address, and to participate in the OSPF realm. The administrator also wants the router ID to be stable and available, even if some links on the switch fail. What should the administrator do?
Options
- AConfigure 10.0.0.1 as a secondary IP address on the switch OOBM port
- BConfigure 10.0.0.1 as a manual OSPF neighbor on each switch in the OSPF system
- CMake sure that 10.0.0.1 is the IP address on the VLAN with the lowest ID
- DConfigure 10.0.0.1 on a loopback interface and enable OSPF on that interface
How the community answered
(33 responses)- A12% (4)
- B3% (1)
- C6% (2)
- D79% (26)
Community Discussion
No community discussion yet for this question.