Which parameter is defined within the Enclosure Group for HPE Synergy?

Question

Options

• ANetworks or network sets included in uplink set.
• BMethod of assigning IPs for iLO and interconnect.
• CFirmware baseline for all HPE Synergy components.
• DRequested speed of the downlink ports.

• B
  91% (31)
• C
  3% (1)
• D
  6% (2)

Explanation

Option B is correct because the Enclosure Group in HPE OneView for Synergy specifies the IP addressing mode - DHCP, user-specified, or IP pool - used to assign management IPs to iLO interfaces and interconnect modules across the enclosure.

Option A is a distractor because uplink sets (which define which networks or network sets are linked to uplinks) are configured within a Logical Interconnect Group (LIG), not the Enclosure Group itself. Option C is incorrect because firmware baselines are applied through Server Profiles or Server Profile Templates, not the Enclosure Group. Option D is wrong because downlink port speed settings are also defined in the Logical Interconnect Group, which handles interconnect-level port behavior.

Memory tip: Think of the Enclosure Group as the "address registration desk" for an entire frame - its primary job is telling OneView how to reach each component (iLO, interconnects) by governing IP assignment, while the LIG handles the actual network wiring details.

No community discussion yet for this question.