What step must be taken to add an HPE SuperDome Flex to an existing OneView environment

Question

Options

• AA Rack Management Controller must be added to HPE OneView.
• BHPE Superdome Flex can be added to HPE OneView after at least one nPAR is created.
• CEach HPE Superdome Flex chassis must be added Individually using BMC IP.
• DHPE Superdome Flex complex can be added by adding base chassis of this complex.

• A
  95% (41)
• B
  2% (1)
• C
  2% (1)

Explanation

Adding an HPE SuperDome Flex to OneView requires first adding its Rack Management Controller (RMC) - this is the centralized management component that acts as the gateway between OneView and the entire SuperDome Flex complex, enabling unified visibility and control.

Why the distractors are wrong:

• B is incorrect because nPAR creation is an action performed after the system is already managed by OneView, not a prerequisite for adding it.
• C is incorrect because SuperDome Flex does not use a traditional BMC (Baseboard Management Controller) per chassis - the RMC replaces that role for the entire complex, so there is no individual BMC IP to add.
• D is incorrect because you cannot add the complex by targeting just the base chassis; the RMC is the single management entry point for the whole system regardless of chassis count.

Memory tip: Think "RMC = Remote Management Command post." Just like a military operation runs through a command post before troops can be deployed, OneView must connect through the RMC before it can manage any part of the SuperDome Flex complex.

No community discussion yet for this question.