Drag and Drop Question You have to enable auto-zoning functionality in HPE OneView. Put the steps to complete this task into the correct order in the answer area on the right. Answer:

Question

Exhibit

Answer Area

Explanation

HPE OneView Auto-Zoning: Step-by-Step Explanation

Auto-zoning in HPE OneView automates the creation of FC zones when storage is assigned to servers. The steps follow a logical discover → configure → validate → deploy sequence.

Step 1: Import SAN Manager

Why first: OneView cannot interact with the SAN fabric until it has a management connection to the SAN manager (e.g., Brocade Network Advisor or Cisco DCNM). This step gives OneView visibility into the physical FC switches and their existing zone configurations. Without this, the remaining steps are impossible - OneView is blind to the fabric.

Common mistake: Skipping this and trying to associate networks first. OneView has nothing to associate with yet.

Step 2: Associate SAN with FC Network

Why second: Once the SAN manager is imported and the SAN fabric is discovered, you map the physical SAN to a logical FC network object inside OneView. This is the step that enables auto-zoning - it tells OneView which fabric to push zone changes to when server profiles request storage.

Common mistake: Assuming auto-zoning is enabled by default without this association. The link between the logical network and the physical SAN is what unlocks the feature.

Step 3: Verify Proper Zoning on FC Switches

Why third: After the association is established, OneView may push an initial zone configuration or inherit existing zones. You verify that the FC switch zoning reflects a correct, healthy state before presenting any volumes. This is a pre-deployment sanity check - confirming the fabric is ready and auto-zoning is functioning as expected.

Common mistake: Skipping this step and discovering misconfigured zones after volumes are already presented, which makes troubleshooting harder.

Step 4: Present the Volume to the Compute Node via Server Profile

Why last: With the fabric verified, you now create or update a server profile that includes a SAN storage volume assignment. This action triggers OneView's auto-zoning engine to automatically create the appropriate initiator-target zones on the FC switches. The compute node can then access the storage.

Common mistake: Treating this step as optional or doing it before verifying zoning - presenting a volume to a broken fabric will result in no storage connectivity and a confusing failure mode.

Key Takeaway

The order enforces a dependency chain: you must manage the fabric before configuring it, configure it before validating it, and validate it before deploying workloads through it. Each step is a prerequisite for the one that follows.

No community discussion yet for this question.