HP
HPE0-S48 · Question #50
Refer to the exhibit. A customer is using HPE OneView and HPE c7000 BladeSystem Enclosure with BL460c Gen9 server blades. The integrator changed a server blade in a bay, but profile settings were…
The correct answer is A. Change Affinity to Device bay in the General section. See the full explanation below for the reasoning.
Question
Refer to the exhibit. A customer is using HPE OneView and HPE c7000 BladeSystem Enclosure with BL460c Gen9 server blades. The integrator changed a server blade in a bay, but profile settings were not applied. Which change should the integrator make in the server profile shown to avoid this situation in the future?
Exhibit
Options
- AChange Affinity to Device bay in the General section.
- BChange Server hardware to Unassigned before removing the server blade from the bay
- CIncrease the auto-generated MAC Address range
- DSelect the Force installation checkbox in the firmware section.
How the community answered
(55 responses)- A80% (44)
- B2% (1)
- C5% (3)
- D13% (7)
Community Discussion
No community discussion yet for this question.