HP
HPE0-J50 · Question #60
During the startup of an HPE StoreOnce backup system the fabric ports do not show up as active. All fabric cables are attached to the HPE StoreOnce backup system and to the customer's SAN. What…
The correct answer is B. The HPE StoreOnce fabric cable is not connected to the correct SAN switch ports. See the full explanation below for the reasoning.
Question
During the startup of an HPE StoreOnce backup system the fabric ports do not show up as active. All fabric cables are attached to the HPE StoreOnce backup system and to the customer's SAN. What would be causing this problem?
Options
- AThe SAN Switch is not configured for Access Gateway Mode.
- BThe HPE StoreOnce fabric cable is not connected to the correct SAN switch ports.
- CThe SAN switch has NPIV enabled on the ports connected to the HPE StoreOnce.
- DThe HPE StoreOnce backup device HBA is only licensed for the SAN switch fabric.
How the community answered
(23 responses)- A9% (2)
- B74% (17)
- C4% (1)
- D13% (3)
Community Discussion
No community discussion yet for this question.