A customer is planning to deploy HP MSM466-R access points in an extreme cold environment to interconnect to the Unified Wired-WLAN Module in the HP switch. Which requirement is needed to accomplish…

Question

Options

• ANEMA 4X enclosures should be used to house the access points.
• BSwitch ports must support PoE.
• CPoE redundancy must be enabled on the interface.
• DAccess Point must deploy internal antennas.

• A
  3% (2)
• B
  5% (3)
• C
  76% (45)
• D
  15% (9)

Explanation

Preventing untagged packets on the physical interface--If you use subinterfaces, you typically do not also want the physical interface to pass traffic, because the physical interface passes untagged packets. This property is also true for the active physical interface in a redundant interface pair. Because the physical or redundant interface must be enabled for the subinterface to pass traffic, ensure that the physical or redundant interface does not pass traffic by leaving out the nameif command. If you want to let the physical or redundant interface pass untagged packets, you can configure the nameif command as usual. See the "Completing Interface Configuration (All Models)" section for more information about completing the interface

No community discussion yet for this question.