HP2-T23 Exam Questions
74 real HP2-T23 exam questions with expert-verified answers and explanations. Page 1 of 2.
- Question #1
How do you boot into Intelligent Provisioning on a ProLiant Gen8 server?
- Question #2
Which statement has Gartner found to be true regarding the introduction of a new vendor into the infrastructure?
- Question #3
What is a distinguishing feature of flash-backed write cache (FBWC)?
- Question #4
Which statement is correct about the HP iLO Management Engine?
- Question #5
What should you use to update firmware on several HP VC Ethernet or Fibre Channel modules simultaneously?
- Question #6
Which statements are correct about the HP Customer Self Repair (CSR) program?
- Question #7
What are the upgrade options for HP FlexLOM? (Select two.)
- Question #8
Which memory configuration types are supported in the ProLiant Gen8 server blades? (Select two.)
- Question #9
An administrator must replace a defective processor located in slot 1 in an Intel-based ProLiant DL5860 Gen8 server: What should the administrator do?
- Question #10
You need to capture the configuration and support dump of several Virtual Connect domains. Which tool can you use to perform this action from a central system?
- Question #11
Which HP tools should you use to determine that an SSD drive has degraded as a result of a large number of write operations? (Select three.)
- Question #12
Which tool can report the amount of life remaining in an HP solid state drive (SSD)?
- Question #13
An engineer replaced a tape drive that failed. What is the best method for testing this drive during business hours?
- Question #14
An administrator installed HP CS Platinum/Platinum Plus Power Supplies in an enclosure with ProLiant server blades. Which additional components does the administrator need in order...
- Question #15
An HP P421/1GBFBWC controller with three hard disks is configured as RAID 5. What is the minimum requirement to upgrade the disk configuration to RAID 60? (Select two.)
- Question #16
You need to check the firmware revision of the disk drives installed in a ProLiant DL380Gen8 server. What can you use to check the revision while the server is online?
- Question #17
Which Virtual Connect module enables FCoE or iSCSI connectivity for BladeSystem server blades?
- Question #18
A server has been shutting down sporadically for the past two months. Version Control Repository Manager (VCRM) is not installed or configured. Where can you locate the latest vers...
- Question #19
What can an engineer use to ensure quick, precise, intelligent installation when installing CPUs in a ProLiant Gen8 server?
- Question #20
You are viewing the current driver and firmware status in the Version Control Agent (VCA) and notice that only one column of information is presented. What must you do to see the c...
- Question #21
What should you do if an online firmware flash of the system board fails?
- Question #22
Where can you choose the server SPP for version comparison and updates?
- Question #23
What are features of Option ROM Configuration for Arrays (ORCA)? (Select two.)
- Question #24
After a system administrator replaces a system board on an HP server blade, the BIOS update fails. After it reboots, the server works with the old BIOS version. What is the next st...
- Question #25
Which host management solution does HP recommend using with ProLiant Gen8 servers?
- Question #26
A support engineer is installing DlUMs of different speeds and voltages in a ProLiant DL380p Gen8 Server. Which rules for DIMM installation must the engineer follow during this ins...
- Question #27
A customer has a ProLiant DL380p Gen8 server with one CPU and four 16 GB RDIMMs with 24 total DIMM slots. The customer wants to increase the memory in this server. Which memory opt...
- Question #28
Which button should you press to enter the RBSU during POST?
- Question #29
You are troubleshooting a problem with a ProLiant BL460c Gen8 server and need a report detailing the firmware and driver revisions on the server. Which report should you obtain?
- Question #30
A customer placed a service call after installing genuine HP memory from a ProLiant DL380 Gen7 server into a new ProLiant DL380 Gen8 server and receiving a POST message that the me...
- Question #31
You cannot get to the network from any of the server blades in a c7000 enclosure with 10GbE Pass-Thru modules. What should you verify first for proper connectivity to the network?
- Question #32
Which statements are correct about HP Systems Insight Manager (HP SIM) 7.0 Agentless Management? (Select two.)
- Question #33
Which statements are correct about HP Systems Insight Manager (HP SIM) 7.0 Agentless Management? (Select two.)
- Question #34
A customer lost the password information for the Onboard Administrator of a C7000 enclosure and asks you to restore administrator access. How should you do this?
- Question #35
Microsoft Windows BitLocker Encryption feature uses a TPM microcontroller chip to store certificates and encryption keys on a DL380 G7. Which action must a field engineer perform b...
- Question #36
What is the name of the HP agent that enables a customer to manage HP software that is stored in a user-defined repository?
- Question #37
What happens if you lose or misplace a Trusted Platform Module (TPM) key?
- Question #38
An engineer is installing an HP R7000 UPS and an Extended Runtime Module (ERM) in an existing HP 10642 G2 rack. This rack contains 10 ProLiant DL380e Gen8 servers mounted from 1U u...
- Question #39
Which RAID level is known as Advance Data Guarding (ADG)?
- Question #40
Which HP utility can patch a ProLiant server with a release set made up of drivers, firmware, and software that have been tested together?
- Question #41
An engineer repaired a memory problem in a ProLiant BL460c Gen8 server blade running Windows 2008 R2. What should the engineer do to verify the repair? (Select two.)
- Question #42
What is a result of selecting the Allow Non-Bundled Versions in HP SUM?
- Question #43
What should a system administrator use to save an enclosure backup?
- Question #44
What do you need to manage and control an InfiniBand fabric?
- Question #45
To boot a USB firmware memory key built by the HP USB key utility, where should an engineer insert the key to upgrade the firmware on the server blade?
- Question #46
The system ROM is causing memory errors in a customer's mission-critical server blade. After you update the system ROM in this server blade, how can you confirm that the other serv...
- Question #47
Which RAID level allows the data to be striped across multiple RAIDs? (Select two.)
- Question #48
Which step must be performed after the system board is replaced on a ProLiant BL460c G8 server blade?
- Question #49
What should be installed on a ProLiant Gen8 server to display operating system information within the iLO 4 GUI?
- Question #50
What are some general requirements that must be met to update Virtual Connect firmware? (Select three.)