HP
HP0-Y49 · Question #3
Refer to the exhibit. Exhibit Switch configuration. A network administrator is configuring an aggregated link between an HP Comware and ProVision switch. The network administrator applies the…
The correct answer is C. The Commware switch must initiate LACP for the link to become active. See the full explanation below for the reasoning.
Question
Refer to the exhibit. Exhibit Switch configuration. A network administrator is configuring an aggregated link between an HP Comware and ProVision switch. The network administrator applies the configurations to the switches, as shown in the exhibit. The two links on the both switches are up, and they can see each other on both links in the local LLDP table. What will be the outcome?
Exhibit
Options
- AThe ProVision switch must initiate LACP for the link become active
- BLink aggregation fails because the VLAN tagging was not configured correctly
- CThe Commware switch must initiate LACP for the link to become active
- DLink aggregation fails because of a protocol issue
How the community answered
(29 responses)- A7% (2)
- B3% (1)
- C86% (25)
- D3% (1)
Community Discussion
No community discussion yet for this question.