HP0-Y43 Exam Questions

A customer requires an HP FlexCampus solution with a core that scales to 40/100G. Which HP switch fabric meets this need?

What is the role of neighbor solicitation (NS) messages in the autoconfiguration of an IPv6 address?

Which switch is best suited to act at the edge of a medium to large HP FlexFabric solution?

How can a high density of ports and high throughput at the core of an HP FlexNetwork save customers money?

View the exhibit. The exhibit shows a network with HP 5400 zl and 8200 zl switches throughout the core and edge. What is one advantage of implementing routing on edge switches?

A company has a network that includes HP 5800 and 12500 switches. Usage demands on the company's FTP servers have increased, causing performance issues during peak usage times. Whi...

View the exhibits. Exhibit 1 The frame has these characteristics: - VLANID = 3 - 802.1p = 3 - DSCP=32 - Source IP address = 10.1.1.5 Exhibit 2 The frame shown in Exhibit 1 arrives...

View the exhibit. A network administrator wants to configure an HP 5800 switch to place all incoming traffic on the GigabitEthernet 1/0/1 port in priority queue 3. However, one exc...

A company has a service level agreement (SLA) with its service provider. The SLA specifies a 2 Mbps committed information rate (CIR) and 20 KB committed burst size (CBS). Lately, d...

A network includes a mix of IGMPv2 and IGMPv3 endpoints and must support the following source specific multicasting applications: * Source: 10.1.4.2 and Group: 232.0.5.5 * Source:...

View the exhibit. PIM-SM is configured on each interface in the network and IGMP is enabled on VLAN 3 and VLAN 4, as shown in Exhibit 1. Each switch has a rendezvous point (RP) set...

View the exhibit. A host connected to routing switch A joins group 239.0.0.1. Which switch does routing switch A select as the RP? HP HP0-Y43 Exam

A network uses PIM-DM to route multicast traffic. The network administrator has noticed bursts of congestion related to periodic floods of multicast traffic. How can the administra...

View the exhibit. An HP 5400 zl switch implements the configuration shown in the exhibit. However, when the network administrator tests the configuration, endpoints in VLAN 10 do n...

View the exhibit. A site features both IPv6 and IPv4 endpoints and IPv4 and IPv6 capable servers in the data center, as shown in the exhibit. How can the network administrator conf...

View the exhibit. All switches shown in Exhibit 1 are HP Provision ASIC switches, which are implementing IGMP and multicast routing with PIM. Routing switch B has just received the...

Two HP 7500 switches, switch A and switch B, are implementing VRRP in VLAN 2 (VRID 2) and in VLAN 3 (VRID 3). Switch A is currently the master in both VRIDs. The network administra...

Which type of IPv6 over IPv4 tunnel protocol on an HP 12500 switch requires that you specify a destination?

A network administrator enabled IPv6 on an HP 7500 switch and configured VLAN interface 10 with a link-local and global IPv6 address 2001:DB8:1:10::1/64. The network administrator...

View the Exhibit. A network administrator configures VRRP on two HP 5800 switches, as shown in the exhibit. VRRP settings not shown in the running-config are at their default setti...

View the exhibit. Based on the information provided in the exhibit, which IP address should this switch use as its router ID for OSPF? HP HP0-Y43 Exam

What are functions of Type 9 LSAs in OSPFv3? (Select two.)

A network administrator is configuring OSPF on an HP 5400 zl switch and has enabled OSPF globally. What is the minimum configuration required for the switch to begin sending OSPF h...

View the exhibit. Part of an OSPF routing table in an HP 5800 switch is shown in the exhibit. This switch is an internal switch in area 1. The network administrator views this rout...

View the exhibits. Exhibit 1 The frame has these characteristics: - VLAN tag: 2 - Source MAC address: 000b-cdbb-3cc9 - Source IP address: 10.1.4.12 Click here for Exhibit 2 HP HP0-...

View the exhibit. The HP 5406 zl switch configured with the VLANs shown in the exhibit receives a packet on a port that is an untagged member of VLAN 101. The packet is tagged with...

A service provider has configured an HP 5406 zl switch to support QinQ in mixed mode. Port A1 is a member of C-VLAN 100. Which usage is supported by this configuration?

A company manages thousands of network infrastructure devices from several vendors with HP Intelligent Management Center (IMC). What advantage does the HP IMC distributed deploymen...

A company campus LAN requires high availability, so all edge switches have redundant links to the core. As part of the high availability design, all switches implement Multiple Spa...

View the exhibit. Topology 1 and topology 2 shown in the exhibit feature redundant gateways that implement Virtual Router Redundancy Protocol (VRRP). What is the advantage of topol...

A company is updating its campus LAN infrastructure, which includes a Unified Communications and Collaboration (UC&C) solution that features VoIP. What is the benefit of using HP 8...

A campus LAN solution consists of HP Provision ASIC switches at the core and edge. Routing is implemented at the core. What is one common design principal for such a solution?

View the exhibit. All switches in this figure are HP Provision ASIC switches. They are enabled to establish adjacency with neighbors on all of their VLAN interfaces. Besides these...

Before you enable dynamic IP lockdown on an 5400 zl switch, which feature must be enabled first?

What is true about using EAP-Transport Layer Security (EAP-TLS) in the 802.1X process?

A network administrator wants to configure the precise MAC addresses that are allowed to send traffic on a particular port on an HP 5400 zl Series switch. No other addresses can se...

Which statement accurately describes how network administrators can apply routed access control lists (RACLs) or VPN access control lists (VACLs) on an HP 8200 zl switch?

What is the first step a network administrator should complete to configure the first remote mirroring session between an HP 5400 zl and an HP 8200 zl switch?

A network administrator enables OSPF on an HP Provision ASIC switch and creates area 0 and area 1. The network administrator then enters this command: Switch(ospf)# area 1 range 10...

View the exhibit. Assume that this HP 10500 routing switch achieves adjacency with neighbors in Area 0 and Area 1. Based on the information provided in the exhibit, which statement...

View the exhibit. Area 1 and Area 2 in the topology are associated with/21 subnets, shown in Exhibit 1. All of the switches in this topology are HP Provision ASIC switches, and the...

View the exhibit. The OSPF routing table and OSPF settings on an HP 7500 Series routing switch are shown in the exhibit. Which networks does this switch advertise as summary LSAs i...

Two HP Provision switches are configured as virtual routers. How does the VRRP backup know if the VRRP master is available and functioning?

View the exhibit. In the example network shown in the exhibit, switch A loses power and becomes unavailable. Which switch ports have the designated role in instance 1 when the MSTP...

A company wants clients to receive a video stream from a server. What is the advantage of transmitting this stream as multicast traffic rather than unicast traffic?

View the exhibit. An IRF device consists of four HP 5820 switches. The IRF topology is shown in Exhibit 1. The IRF settings are shown in Exhibit 2. After these settings are display...

View the exhibit. The switches shown in the exhibit are HP Provision ASIC switches. Switches A, B, C, and D implement MSTP using the settings shown in the exhibit. Switches B and C...

View the exhibit. An HP 5406 zl switch is configured as shown in the exhibit. The switch receives a frame on VLAN 10, destined to UDP port 5555. The frame is marked 802.1p value 6...

A company's HP Provision ASIC switches are configured to use PIM-SM mode to provide multicast services. When an HP Provision ASIC switch receives a multicast stream, it determines...

View the exhibit. A network administrator configures the HP 2610-24-PoE switch as shown in the exhibit. Computers belong to the data VLAN, which is VLAN 10. IP phones should transm...