Power was lost to an HP ProLiant DL380 Gen3 Server. The system ROM is now corrupted and the server can no longer boot. What should the integrator do first to correct this problem?

Question

Options

• ARelocate the redundant ROM chip to the primary ROM chip.
• BReplace the system board.
• CRemove the system board battery for 60 seconds.
• DSet the system maintenance switch positions S1,S5, and S6 to on.

• A
  17% (4)
• B
  9% (2)
• C
  4% (1)
• D
  70% (16)

Explanation

If the system ROM on a HP ProLiant DL380 server is corrupted, the system automatically switches to the redundant ROM in most cases. If the system does not automatically switch to the redundant ROM, perform the following steps: 1. Power down the server. 2. Remove the server from the rack, if necessary. 3. Remove the access panel. 4. Change positions 1, 5, and 6 of the system maintenance switch to on. 5. Install the access panel. 6. Install the server into the rack. 7. Power up the server. 8. After the system beeps, repeat steps 1 through 3. 9. Change positions 1, 5, and 6 of system maintenance switch to off. 10. Repeat steps 5 and 6. If both the current and backup versions of the ROM are corrupt, return the system board for a interupted-on-HP-DL380-G6-uh-oh/td-p/6247481

No community discussion yet for this question.