H31-161 Exam Questions
190 real H31-161 exam questions with expert-verified answers and explanations. Page 2 of 4.
- Question #51
acl number 2000 rule 15 permit source 225.0.0.0 0.0.0.255 # interface Ethernet6/1/1 ip address 40.1.1.4 255.255.255.0 igmp version 3 igmp group-policy 2000 igmp enable pim sm # The...
- Question #52
<Quidway>display current-configuration # multicast routing-enable # interface Ethernet6/1/0 ip address 10.1.1.1 255.255.255.0 igmp timer query 40 # Igmp The preceding are partial m...
- Question #53
<Quidway>display current-configuration multicast routing-enable # acl number 2000 rule 5 permit source 225.0.0.0 0.0.0.255 # interface Ethernet6/1/0 ip address 10.1.1.1 255.255.255...
- Question #54
<Quidway>display igmp group IGMP interface group report information of VPN-Instance: public net Ethernet6/1/1(40.1.1.1): Total 1 IGMP Group reported Group: 232.0.0.1 Uptime: 00:00:...
- Question #55
# interface Ethernet6/1/1 ip address 40.1.1.4 255.255.255.0 igmp prompt-leaveigmp enable pim sm # IGMP interface group report information of VPN-Instance: public net Ethernet6/1/1(...
- Question #56
[Quidway]multicast routing-enable [Quidway]interface Ethernet10/1/0 [Quidway-Ethernet10/1/0]igmp enable [Quidway-Ethernet10/1/0]igmp robust-count 4 [Quidway-Ethernet10/1/0]quit [Qu...
- Question #57
In PIM-DM, which of the following scenarios about sending Join messages is true?
- Question #58
In PIM DM, which of the following statements about state-refresh message processing are true?
- Question #59
# pim c-rp Ethernet6/2/0 timer hello 100 state-refresh-interval 10 state-refresh-ttl 60 Interface Ethernet6/2/0Ip address 20.1.1.3 255.255.255.0 Pim timer hello 45 Pim dm # Which o...
- Question #60
As shown in the figure, RTA, RTB, and RTC use the OSPF protocol. The default cost value is used for links, and unicast routes converge on the entire network. The Loopback 0 interfa...
- Question #61
In PIM-SM, how does each router learn the location of the RP?
- Question #62
If a (*, G) entry exists in the RP, which of the following statements about the source registration process are true in PIM-SM?
- Question #63
When the multicast source starts to send multicast data and no receiver joins in the RP in PIM- SM, which of the following statements are true?
- Question #64
Multicast configurations in PIM-SM are as follows: # multicast routing-enable # acl number 2000 rule 5 permit source 239.0.0.0 0.0.0.255 rule 10 deny # acl number 2999 rule 5 permi...
- Question #65
Which of the following are rules for the router to check the RPF after receiving SA messages from the MSDP?
- Question #66
Configurations are as follows: # multicast routing-enable # msdp peer 2.2.2.2 connect-interface loopback0 peer 3.3.3.3 connect-interface loopback0 import-source acl 3000 peer 2.2.2...
- Question #67
What is the SSM group address range the IANA allocates for IPv4?
- Question #68
Which multicast protocol can support the SSM? (
- Question #69
Which statement is false?
- Question #70
The Huawei router is the last hop DR where the SSM Mapping function is enabled at the interface. Some IGMPv2 hosts expect to receive (1.0.0.1, 232.1.0.1), (1.0.0.1, 232.1.0.2), and...
- Question #71
Which statement is false?
- Question #72
RTA is a leaf router that directly connects to host A through interface GigabitEthernet 1/0/0. The interface is configured as follows: interface GigabitEthernet1/0/0 undo shutdown...
- Question #73
RTA is a leaf router that directly connects to host A through interface GigabitEthernet 1/0/0. The interface is configured as follows: interface Ethernet1/0/0 undo shutdown ip addr...
- Question #74
The secure sockets layer (SSL) protocol mainly provides confidentiality and reliability between communication applications. It is found at the transport layer and the application l...
- Question #75
In the VRP, which of the following authentication modes are supported by the secure shell (SSH)?
- Question #76
The RADIUS or Huawei Terminal Access Controller Access Control System (HWTACACS) protocol can be used for authentication during network access. Which of the following statements ab...
- Question #77
Which of the following statements about the Dynamic Host Configuration Protocol (DHCP) snooping function are true?
- Question #78
On the BGP network, which of the following policies can be used to prevent BGP-targeted attacks?
- Question #79
In the access architecture of an IP bearer network, the OSPF protocol is enabled between two access routers, two firewalls (in transparent mode), and two Layer 3 switches. Softswit...
- Question #80
On a city's dual-plane bearer network, PE1-A and PE1-B are two PEs in different planes of the city. Three CEs are on the same VPN. The OSPF is used to exchange VPN route informatio...
- Question #81
On the typical access network of a bearer network, a core network device connects to two upstream CEs. CEs connect to PEs in a square shape. This access network must bear voice and...
- Question #82
On the MPLS Layer 3 VPN, PE security is key to the safety of the entire network. Which of the following security measures can be deployed on PEs?
- Question #83
On a metropolitan area network, VIP customers access the network through the MPLS VPN to ensure their security. Which of the following security deployments are required for PEs?
- Question #84
An IPTV bearer network requires the broadband TV (BTV), VOD, and near video on demand (NVOD) services. Video programs use the standard MPEG 4 codec format. Which of the following s...
- Question #85
A gold user and a common user access a carrier network through the MPLS Layer 3 VPN. On the entire MPLS network (from PE to PE), the carrier performs queue scheduling for the gold...
- Question #86
User A wants to obtain a better network service for business development and signs an SLA with a carrier. User A purchases a bandwidth of 5 Mbit/s to ensure the voice service (requ...
- Question #87
On the IP bearer network, media and signaling packets must first be guaranteed by PQ scheduling. The IP priority of protocol packets on the routers is 6 or 7, and these packets mus...
- Question #88
Which functions does the bearer network NMS mainly provide?
- Question #89
On the IP bearer network, which of the following methods can be used to manage devices on the backbone network and switches on the signaling VPN?
- Question #90
Which statement about the Ethernet clock synchronization technology used in actual solutions is true?
- Question #91
Which command is used to query the aging time of the firewall session .
- Question #92
For the Eudemon firewall, the nat-policy command is configured in which mode?
- Question #93
Which kind of encryption algorithms is more excellent in security When configure IPSec VPN
- Question #94
Which of the following statements about the working principle of LDP FRR are true?
- Question #95
The Advanced Research Projects Agency Network (ARPANET) network is created by United States Department of Defense and is the predecessor of the contemporary global. Which of the fo...
- Question #96
Which of the following are the advantages of RSTP compared with STP? (Select multiple)
- Question #97
Which statements about the edge access layer is true?
- Question #98
Which statement describes the delay variation requirement of the voice service for the IP bearer network?
- Question #99
Which statement describes the packet loss ratio requirement of the voice service for the IP bearer network?
- Question #100
Which of the following can be implemented in an IP backbone network?