Huawei
H12-821_V1.0 · Question #529
In the network shown in the figure, R1 and R2 run IS-IS and establish an adjacency relationship. The Loopback0 interface of R2 enables IS-IS, and the Loopback3 interface of R2 does not enable IS-IS…
The correct answer is B. The route 10.0.2.2/32 exists only in the routing table of R1. See the full explanation below for the reasoning.
IPv4 Routing Technologies
Question
In the network shown in the figure, R1 and R2 run IS-IS and establish an adjacency relationship. The Loopback0 interface of R2 enables IS-IS, and the Loopback3 interface of R2 does not enable IS-IS. Under the IS-IS process of R2, do as follows. Which of the following statements about the configuration shown in the figure is correct? (Multiple choice)
Options
- AThe routes 10.0.2.2/32 and 10.0.2.3/32 do not exist in the routing table of R1
- BThe route 10.0.2.2/32 exists only in the routing table of R1
- CThere is a route of 10.0.2.3/32 in the routing table of R1
- DThere is a route of 10.0.2.3/32 in the routing table of R1
How the community answered
(45 responses)- A2% (1)
- B76% (34)
- C7% (3)
- D16% (7)
Topics
#IS-IS routing table#Loopback interface#IS-IS redistribution#IS-IS adjacency
Community Discussion
No community discussion yet for this question.