H12-811_V1.0 Exam Questions
982 real H12-811_V1.0 exam questions with expert-verified answers and explanations. Page 17 of 20.
- Question #807Datacom Network Fundamentals
On the network shown in the figure, Host A and Host B cannot communicate with each other.
network connectivityIP addressingsubnet communicationtroubleshooting - Question #809IP Routing Technologies
By referring to the network structure and OSPF areas shown in the figure, it can be determined that all routers on the network except RTA are ABRs.
OSPFABRmulti-area OSPFarea border router - Question #810IP Routing Technologies
Which of the following elements are included in a routing table?
routing tablecostprotocoldestination mask - Question #811Network O&M
In the case of Huawei routers, what is the "-i" parameter in a Ping command issued on a VRP operating system used to set?
ping commandVRPICMPsource IP address - Question #812Ethernet Switching Technologies
The load balancing modes at both ends of an Eth-Trunk can be different.
Eth-Trunklink aggregationload balancingLAG - Question #813Ethernet Switching Technologies
Refer to the following configuration of an interface on a switch. For which VLAN does the interface transmit tagged data frames? interface GigabitEthernet0/0/1 port hybrid tagged v...
VLANhybrid porttagged framesport configuration - Question #814Ethernet Switching Technologies
Which of the following BIDs cannot be contained in a configuration BPDU sent by a switch?
STPbridge IDBPDUMAC address validity - Question #815Ethernet Switching Technologies
As shown in the figure, which of the following ports will be in a blocking state?
STPblocking stateport role selectionspanning tree topology - Question #816Ethernet Switching Technologies
Which of the following port statuses may exist on an STP-enabled switch?
STPport statesdiscardingforwarding - Question #817Ethernet Switching Technologies
Which of the following parameters is used to elect the root bridge in STP?
STProot bridge electionbridge IDspanning tree - Question #818Ethernet Switching Technologies
The following figure shows the display interface Eth-Trunk 1 command output on a switch. Which of the following commands can be used to delete Eth-Trunk 1?
Eth-Trunklink aggregationinterface deletionVRP configuration - Question #819Ethernet Switching Technologies
In STP, the bridge ID on the switching network is as follows. With which of the following bridge IDs is the switch selected as the root bridge?
STProot bridgebridge IDpriority comparison - Question #820IP Routing Technologies
The following figure shows the configuration of a sub-interface on a router. For which VLAN does the sub-interface receive tagged data frames?
sub-interfacedot1q encapsulationVLAN taggingrouter-on-a-stick - Question #821Ethernet Switching Technologies
Refer to the following configuration of an interface on a switch. What is the PVID of the interface? interface GigabitEthernet0/0/1 port hybrid tagged vlan 2 to 3 100 port hybrid u...
hybrid interfacePVIDuntagged VLANport configuration - Question #822Ethernet Switching Technologies
Refer to the graphic, after the ping 10.1.1.2 command is executed on R1, LSW1 receives a tagged data frame from VLAN 10 on LSW2.
VLAN taggingtrunk linkinter-switchtagged frames - Question #823Ethernet Switching Technologies
Which of the following statements about hybrid interfaces is true?
hybrid interfaceVLAN tagsport link typesuntagged egress - Question #824Ethernet Switching Technologies
As specified by the RSTP protocol, when a root port fails, which type of port will function as a new root port and enter the forwarding state without any delay?
RSTPalternate portroot portfast convergence - Question #825Ethernet Switching Technologies
For STP, the Message Age in the configuration BPDUs sent by the root bridge is 0.
STPBPDUMessage Ageroot bridge - Question #826Ethernet Switching Technologies
SWA and SWB run RSTP. Which of the following statements are true?
RSTPport rolesdesignated portalternate port - Question #827Ethernet Switching Technologies
When a switch port receives a frame that does not carry a VLAN tag, it must add a PVID to the frame.
PVIDuntagged framesVLAN taggingswitch port - Question #828Network Security Basics
An ACL is essentially a packet filter. An ACL takes effect only after it is applied to a service module.
ACLpacket filterservice moduleaccess control - Question #829Network Security Basics
Following a failure of services in the network, an administrator discovered that the configuration in one of the enterprise routers had been changed. What actions can be taken by t...
ACLAAArouter access controlprivilege level - Question #830IP Routing Technologies
Static NAT can only implement one-to-one mapping between private and public addresses.
static NATaddress mappingNAT typesprivate to public - Question #831Network Security Basics
An ACL rule is as follows. Which of the following IP addresses can be matched by the permit rule? rule 5 permit ip source 10.0.2.0 0.0.254.255
ACLwildcard maskIP address matchingpermit rule - Question #832Network O&M
You can run the user-interface maximum-vty command to configure the maximum number of users who can log in to the device through Telnet simultaneously.
VTYTelnetuser-interfaceconcurrent sessions - Question #833Network O&M
The users who log on the router through Telnet are not permitted to configure an IP address. What is the possible reason?
Telnetprivilege leveluser authorizationVTY - Question #834Datacom Network Fundamentals
What packet types are included in DHCP?
DHCPDiscoverRequestOffer - Question #835WLAN Basics
Which of the following IEEE 802.11 standards supports the 2.4 GHz frequency band only?
802.11g2.4 GHzwireless standardsfrequency band - Question #836WLAN Basics
The country code configuration affects the actual transmission frequency and maximum transmission power.
country codefrequency regulationtransmission powerWLAN config - Question #837WLAN Basics
Which of the following WLAN security policies support open link authentication?
WEPopen authenticationWLAN securitylink authentication - Question #838WLAN Basics
Fit APs can provide wireless services independently of an AC.
Fit APACWLAN architectureautonomous AP - Question #839Network O&M
Which of the following parts compose SNMP?
SNMPMIBNMSagent process - Question #840Datacom Network Fundamentals
What is the protocol of the Router Advertisement (RA) packet, which is used in IPv6 stateless address auto-configuration?
IPv6 autoconfigurationICMPv6Router Advertisementstateless address - Question #841Network Automation and SDN Basics
SDN requires the control and forwarding planes to be separated.
SDN architecturecontrol planeforwarding planeplane separation - Question #842Network O&M
On the VRP CLI, files cannot be permanently deleted using the delete or delete /unreserved command. To permanently delete them, you need to delete the files in the recycle bin.
VRP CLIfile managementrecycle bindelete command - Question #843Datacom Network Fundamentals
Which of the following networks are LANs?
LANnetwork typesMANWAN - Question #845Network O&M
< Huawei > system-view [Huawei]command-privilege level 3 view user save Refer to the command output. What is the result of the shown command?
VRP CLIcommand privilegeuser viewprivilege level - Question #846Datacom Network Fundamentals
Making a call on a landline telephone is a type of network communication.
network communicationtelephone networkdata communication - Question #847IP Routing Technologies
On Huawei routers, which of the following is the default preference of static routing?
static routingroute preferenceadministrative distanceHuawei VRP - Question #848IP Routing Technologies
Dynamic routing protocols can automatically adapt to network topology changes.
dynamic routingtopology changesrouting protocolroute adaptation - Question #849IP Routing Technologies
An administrator wishes to configure a floating static route. In order to successfully achieve this, which operation should be performed?
floating static routeroute preferencebackup routestatic routing - Question #850IP Routing Technologies
Which of the following is not a type of OSPF LSA?
OSPF packet typesLSALSULSR - Question #851Datacom Network Fundamentals
If the application-layer protocol is Telnet, what is the value of the "Protocol" field in the IPv4 header?
IPv4 headerprotocol fieldTCPTelnet - Question #852Datacom Network Fundamentals
A company applies for a class C IP address for subnetting. It has six branches and the largest branch should have 26 hosts. What would be an appropriate subnet mask for the largest...
subnettingsubnet maskclass Chost calculation - Question #853IP Routing Technologies
What is the protocol number of OSPF at the network layer?
OSPFIP protocol numbernetwork layerrouting protocol - Question #854Datacom Network Fundamentals
A network administrator wishes to assign an IP address to a router interface G0/0/0. Which of the following IP addresses can be assigned?
IP addressingvalid unicast addressloopback addressspecial addresses - Question #855IP Routing Technologies
The priority of static routes cannot be manually specified.
static routingroute preferencemanual configurationHuawei VRP - Question #856Datacom Network Fundamentals
Which of the following IP addresses can be used by another host to communicate with the host whose IP address is 200.200.200.201/30 without the need to forward traffic through a ro...
subnetting/30 subnetsame subnet communicationhost addressing - Question #857IP Routing Technologies
What are the advantages of OSPF?
OSPF featuresload balancingarea partitionCIDR - Question #858Ethernet Switching Technologies
In RSTP, an edge port becomes a common STP port after receiving a configuration BPDU.
RSTPedge portBPDUport role transition