H12-811_V1.0 · Question #818
The following figure shows the display interface Eth-Trunk 1 command output on a switch. Which of the following commands can be used to delete Eth-Trunk 1?
The correct answer is C. undo interface Eth-Trunk 1. To remove the Eth-Trunk interface, you can simply use the undo interface Eth-Trunk 1 command. This command deletes the entire Eth-Trunk interface from the switch configuration. The other commands involve additional steps to unbind physical interfaces from the Eth-Trunk, but…
Question
The following figure shows the display interface Eth-Trunk 1 command output on a switch. Which of the following commands can be used to delete Eth-Trunk 1?
Exhibit
Options
- Ainte GigabitEthernet 0/0/1 undo eth-trunk quit inte GigabitEthernet 0/0/2 undo eth-trunk quit undo
- Binte GigabitEthernet 0/0/2 undo eth-trunk quit undo interface Eth-Trunk 1
- Cundo interface Eth-Trunk 1
- Dinte GigabitEthernet 0/0/1 undo eth-trunk quit undo interface Eth-Trunk 1
How the community answered
(36 responses)- A3% (1)
- B6% (2)
- C81% (29)
- D11% (4)
Explanation
To remove the Eth-Trunk interface, you can simply use the undo interface Eth-Trunk 1 command. This command deletes the entire Eth-Trunk interface from the switch configuration. The other commands involve additional steps to unbind physical interfaces from the Eth-Trunk, but these steps are unnecessary if you are deleting the Eth-Trunk interface entirely.
Topics
Community Discussion
No community discussion yet for this question.