H12-323_V2.0 Exam Questions

Which of the following options are correct for describing the spectrum navigation function? (Multiple choice)

In a WLAN network, the working status of the AP will be affected by the surrounding environment. By dynamically adjusting the AP's channel, power, and frequency band, each AP manag...

When using the AP calculator in the CloudCampus app to quickly calculate the number of APs in a mobile office scenario, which of the following parameters should be entered based on...

Which of the following tools can be used when using CloudCampus APP for project delivery? (Multiple choice)

When designing the WLAN network planning for the lecture hall scenario, the engineer proposed two network planning solutions as shown in the figure. Which of the following descript...

In the Huawei terminal dial test solution, after the dial test is completed, the test results will be synchronized to the CampusInsight platform. You can log in to the CampusInsigh...

When an engineer was optimizing the customer's existing network, in order to ensure the Internet access quality of online users, he enabled the weak signal user offline control fun...

On Huawei's CampuslInsight intelligent platform, the wireless user journey function mainly draws user portraits for individual terminal users. Which of the following terminal infor...

A customer is deploying Huawei's cloud management solution on their existing network. All cloud APs are now online, but all APs are working on the same channel, causing serious int...

Which of the following working modes does the AP's wired interface have? (Multiple choice)

In the Portal authentication scenario, WAC is used as the access device. During the authentication process, the Portal user fails to authenticate successfully. What are the possibl...

As terminals have higher and higher requirements for the service experience of WLAN networks, it is increasingly important to associate and connect terminals to appropriate APs. Th...

An engineer configures the user CAC function on a Huawei wireless controller. The relevant commands are as follows. Which of the following descriptions of the configuration command...

Redundant radio frequencies in WLAN networks will cause co-channel interference and waste network capacity. Therefore, which of the following processing strategies does Huawei wire...

In WLAN networking, which of the following descriptions about GI are correct? (Multiple choice)

In WLAN networks, network planning and design are usually optimized for which of the following issues? (Multiple choice)

Use WLAN After Planner completes the network planning steps, it can output the network planning report through the "Export Report Function". Which of the following contents can be...

In a WLAN network, which of the following methods can reduce co-channel interference? (Multiple choice)

An engineer is optimizing the wireless network at a customer site. In order to evaluate the quality of the existing wireless network, he uses a terminal plug-in test tool to perfor...

Which of the following are commonly used tools for wireless network optimization? (Multiple choice)

CampuslInsight provides alarm monitoring functions to help users monitor faults, shorten fault recovery time, and improve network operation and maintenance efficiency. The alarm mo...

An engineer is deploying a wireless network at a customer site. The customer requires the wireless controller to use dual-link hot standby networking. During the configuration proc...

In a Mesh network, engineers found that the MP failed to go online. Which of the following may be the reasons for this problem? (Multiple choice)

Which of the following WAC high-reliability networking modes support load balancing? (Multiple choice)

Which of the following are ways for AP to switch to cloud mode? (Multiple choice)

While collecting information during on-site survey in WLAN network planning project, which of the following are interference sources? (Multiple choice)

In a WLAN network, what are the following advantages of using a PoE switch for power supply compared to using a PoE power adapter for power supply? (Multiple choice)

When planning the network for an education scenario, which of the following descriptions of the sub-scenario network planning solutions are correct? (Multiple choice)

In an enterprise office scenario, there may be a demand for video conferencing access. Which of the following are the characteristics of video conferencing access services? (Multip...

Perform a roaming test through the CloudCampus app. After the test is completed, the roaming record is as shown in the figure below. Which options are correct for describing this r...

In coverage optimization, if the AP uses an external antenna, in addition to adjusting the AP location, you can also adjust the antenna direction to meet the coverage requirements....

The engineer logs in to the wireless controller web interface and checks the AP health details as shown in the figure below. The AP health value is only 30. Which of the following...

During the routine maintenance of the wireless network, engineers use the traditional WLAN network operation and maintenance method to view information on the wireless controller w...

In VRRP hot standby networking, after hot standby is configured on the wireless controller, the master-slave channel cannot be established, and the information on the master device...

An engineer is deploying a wireless network. Guest access uses Portal authentication, the authentication point is the wireless controller, and the authentication server uses iMaste...

In a WLAN network, the WLAN theoretical rate refers to the Wi-Fi air interface link establishment rate. Different Wi-Fi protocol standards correspond to different WLAN theoretical...

In a WLAN network, the formula for calculating the number of scenario-based APs is AP number = (total number of people + B) / C. Which of the following descriptions of B and C are...

Which of the following parameters should be considered when selecting APs for WLAN network planning projects? (Multiple choice)

Use terminal dialing test tools to evaluate the quality of customer networks. After the test is completed, export the test report. The test results show that the Internet uplink pe...

By configuring QoS policies based on application protocols, non-critical services can be prevented from excessively occupying wireless resources and causing packet loss for core se...

In a Mesh network, an engineer checks the Mesh routing in WAC, and the display is as follows. Which of the following descriptions about Mesh networking are correct? (Multiple choic...

Which of the following descriptions about dual-link cold backup and N+1 backup are wrong? (Multiple choice)

In the 802.1X authentication system, if EAP termination is used between the access device and the authentication server, which of the following EAP authentication methods are not s...

Which of the following options are correct in describing the load balancing function? (Multiple choice)

Which of the following issues should be considered when designing a WLAN network plan in a hotel scenario? (Multiple choice)

In a WLAN network, a country code is used to identify the country where the AP radio is located. Different country codes specify different AP radio characteristics, which of the fo...

After the terminal is associated with the wireless signal, log in to the CloudCampus APP and open the network module to view the information of the current connected network, which...

Configuration optimization is mainly carried out on software features, and the user experience is improved by adjusting the configuration parameters of the wireless optimization fu...

Which of the following options are correct about the advantages and disadvantages of the traditional WLAN network operation and maintenance methods and the CampusInsight intelligen...

Which of the following are common faults in WLAN networks? (Multiple choice)