Which of the following descriptions of the Planner operation process about WLAN is correct?

Question

Options

• AImport drawings -> Create a new project -> Place APs -> Set up the environment -> Signal
• BCreate a new project->Import drawings->Set up the environment->Deploy APs->Signal simulation
• CCreate a new project->Import drawings->Deploy AP->Set up environment->Signal simulation
• DImport drawings->Create a new project->Set up the environment->Deploy APs->Signal simulation

• A
  2% (1)
• B
  84% (47)
• C
  5% (3)
• D
  9% (5)

Explanation

Option B reflects the only logical workflow sequence: you must create a project first before anything can be imported into it - options A and D both start with "Import drawings," which is impossible without an existing project to receive them. After importing the floor plan, you set up the environment (defining walls, materials, and obstacles) before deploying APs, because the environment parameters directly affect where APs should be placed for optimal coverage - option C flips this by placing APs before the environment is configured, which would make the subsequent signal simulation inaccurate. Finally, signal simulation runs last to validate the planned deployment.

Memory tip: Use the phrase "Create, Import, Setup, Deploy, Simulate" - think of it like building a house: you get a plot (project), get the blueprints (import drawings), prep the site conditions (environment), build the structure (deploy APs), then test it (signal simulation). Never deploy before you've defined what you're deploying into.

No community discussion yet for this question.