H12-311_V3.0 Exam Questions
476 real H12-311_V3.0 exam questions with expert-verified answers and explanations. Page 3 of 10.
- Question #101
Among the following Huawei APs, which AP supports SFP optical fiber interface?
- Question #102
The architecture of the wireless local area network is mainly divided into the thin AP architecture based on the controller and the traditional independent fat AP architecture.
- Question #103
Which of the following descriptions about thin AP is correct?
- Question #104
According to the network architecture between the AP and the AC, the networking methods can be divided into two-layer networking methods and three-layer networking methods.
- Question #105
The CAPWAP protocol supports two working modes: Split Mac and Local Mac.
- Question #106
If the networking mode of an enterprise wireless network is direct forwarding, then the thin AP can convert 802.11 data packets into Ethernet packets, then perform CAPWAP encapsula...
- Question #107
In PoE terminology, the full name of PSU is Power Supply Unit, which refers to the power supply unit, such as the Ethernet interface of the PoE switch.
- Question #108
For the CAPWAP protocol, which of the following description is wrong?
- Question #109
When the AC is a side-mounted network, if the data is directly forwarded, then data flow () AC, if the data is tunnel forwarding mode, then data flow () AC.
- Question #110
In the following about dual-link backup networking, which of the following description is wrong?
- Question #111
Which of the following description of the management VLAN is correct?
- Question #112
When configuring WLAN networking, which of the following templates should the WMM template be bound to?
- Question #113
Which of the following commands is to add GE 0/0/1 port of Huawei access switch to VLAN100?
- Question #114
For a wireless network using WPA2 PSK authentication and SSID broadcasting, the user can double-click the SSID and enter the correct user name and password to access the network.
- Question #115
What is the command to check the system version running on the AP?
- Question #116
If the PoE function is enabled on the switch, traditional devices cannot be connected to these interfaces.
- Question #117
Each AC device needs to specify the source IP address of the AC in order to establish a CAPWAP tunnel with the AP. An AC can specify up to 2 WLAN source IP addresses.
- Question #118
According to the following configuration example, which of the following statement is correct? [AC] dhcp enable [AC] interface VLANif100 [AC-VLANif100] ip address 10.1.100.1 24 [AC...
- Question #119
If no configuration is made, what is the default authentication method supported by the AP?
- Question #120
If you want to create an open authentication security template, which of the following configuration is correct?
- Question #121
When the AC has only one interface connected to the aggregation layer switch, and user traffic goes out of the public network directly through the aggregation layer switch and does...
- Question #122
What is the maximum number of APs that can be managed by the Huawei plug-in controller ACU board?
- Question #123
Regarding AP6610DN, which of the following statement is wrong?
- Question #124
For the networking architecture of AC+thin AP, which of the following description is wrong?
- Question #125
Which of the following statement about the naming of "AP6010DN" is incorrect?
- Question #126
To create a radio-profile, you must bind wmm-profile, otherwise there will be a configuration error.
- Question #127
In a large-scale wireless network deployment scenario, when the AC is configured as "three-layer networking + bypass mode + direct forwarding", where should the wireless user's gat...
- Question #128
The wireless users of the same user VLAN and the same SSID can access the Internet, but they cannot access each other. What may be the reason for this phenomenon?
- Question #129
In the terminology of PoE, what does AP belong to?
- Question #130
Regarding the networking method, which of the following description is correct?
- Question #131
For WLAN networking diagram, which of the following description is wrong?
- Question #132
AAA is a management framework, which protocol is more commonly used to achieve?
- Question #133
Which algorithm is adopt by the data algorithm of WEP encryption?
- Question #134
When PPPoE authentication is used in WLAN, it has nothing to do with the authentication encryption adopted by WLAN itself.
- Question #135
Which algorithm is used by CCMP encryption?
- Question #136
Among the following encryption methods, which is the safest one?
- Question #137
Which of the following ports can only belong to 1 VLAN?
- Question #138
The length of the IV vector in the TKIP encryption method is () bits.
- Question #139
For shared key authentication, which of the following description is wrong?
- Question #140
CCMP encryption is more secure than TKIP encryption because of which of the following?
- Question #141
To configure the security policy of the wireless network as WEP, you need to configure which of the following security template on the AC6605.
- Question #142
For AC6605, which of the following command can be used to check whether the AP is online?
- Question #143
The wireless network card that only supports TKIP can be upgraded through the driver to support AES encryption.
- Question #144
Which of the following description of PSK authentication is wrong?
- Question #145
Which of the following description of WEP encryption is wrong?
- Question #146
In thin AP networking, which of the following authentication methods does not require AC participation in the authentication process?
- Question #147
Which of the following description about TKIP encryption is wrong?
- Question #148
If the terminal supports both 5GHz and 2.4GHz functions, the AP can configure and control such terminals to access 5GHz preferentially.
- Question #149
Which of the following service model can provide end-to-end QoS service, but the scalability is not good?
- Question #150
Among the following priority queues, which of the following queue has the highest default priority?