Refer to the exhibits. FortiGate has been added to FortiAIOps for management. Which step must be performed on FortiAIOps to add a FortiSwitch device connected to the recently added FortiGate?

Question

Exhibit

Options

• AAdd the FortiSwitch device by submitting its serial number.
• BFortiAIOps requires that the FortiSwitch IP address is submitted.
• CFortiSwitch is added automatically.
• DConfigure the FortiSwitch IP address, user ID, and password

• A
  5% (3)
• B
  2% (1)
• C
  89% (49)
• D
  4% (2)

Explanation

In a LAN Edge deployment: FortiSwitch is managedthrough FortiGate via FortiLink. FortiAIOps integrates withFortiGateas the single managed device; from there it gains visibility intoall Fabric and LAN-edge devices(FortiSwitch, FortiAP) that are registered to that FortiGate. Once the FortiGate is successfully added to FortiAIOps (as shown in the exhibit, statusOnline / Successfully Discovered), all FortiSwitches managed by that FortiGate are: Discovered automatically through the FortiGate-FortiAIOps connection Shown under the appropriate inventory / switch views withno separate onboarding stepfor each This is why no extra IP, serial number, or credential entry is required for FortiSwitch. AandBsuggest manual per-switch onboarding, which is not how FortiAIOps works with LAN Edge. Dsimilarly assumes direct FortiSwitch management, but FortiAIOps talks toFortiGate, not the Therefore the correct behavior is that theFortiSwitch is added automatically (C)once its managing FortiGate is connected to FortiAIOps.

No community discussion yet for this question.