Dell-EMC
E20-885 · Question #162
A customer has two EMC VNX configured to replicate between sites. Each VNX has dual Control Stations. The primary Control Station at the source site fails at 6 p.m. and reboots. At 8 p.m., the…
The correct answer is A. Control stations should be set up using IP aliasing. See the full explanation below for the reasoning.
Question
A customer has two EMC VNX configured to replicate between sites. Each VNX has dual Control Stations. The primary Control Station at the source site fails at 6 p.m. and reboots. At 8 p.m., the customer completes DR testing and observes that CIFS replication does not failover to the target site VNX. Why does CIFS replication not failover to the target VNX during the DR test?
Options
- AControl stations should be set up using IP aliasing.
- BControl stations should be set up using IP Jumbo Frames.
- CControl stations have different software revisions.
- DControl stations have different duplex settings.
How the community answered
(17 responses)- A71% (12)
- B6% (1)
- C12% (2)
- D12% (2)
Community Discussion
No community discussion yet for this question.