Dell
DNDNS-200 · Question #77
Refer to the exhibit. Cables have been plugged-in as shown. The network engineer runs the CLI command "show interfaces status" and interface Fo1/1/1 shows Detached. What is the most likely reason…
The correct answer is A. Switch needs to be rebooted to transition the interface Fo 1/1/1 to stack mode. See the full explanation below for the reasoning.
Question
Refer to the exhibit. Cables have been plugged-in as shown. The network engineer runs the CLI command "show interfaces status" and interface Fo1/1/1 shows Detached. What is the most likely reason for this behavior?
Options
- ASwitch needs to be rebooted to transition the interface Fo 1/1/1 to stack mode.
- BBreakout-option is not supported on the N4000 Series switch.
- CInterface Fo 1/1/1 is disabled.
- DConfiguration was not saved.
How the community answered
(33 responses)- A76% (25)
- B3% (1)
- C15% (5)
- D6% (2)
Community Discussion
No community discussion yet for this question.