Dell
DNDNS-200 · Question #63
A network engineer is modifying an existing VLT configuration with two identical S-Series switches. Each VLT peer must be configured to route on behalf of each other for a period of time during peer…
The correct answer is B. DellSwitch1(config)#vlt-domain 100 DellSwitch1(config-vlt-domain)#peer-routing DellSwitch1(config-vlt-domain)#peer-routing-timeout 20. See the full explanation below for the reasoning.
Question
A network engineer is modifying an existing VLT configuration with two identical S-Series switches. Each VLT peer must be configured to route on behalf of each other for a period of time during peer failure. As part of a larger network, the switches run OSPFv2. Which set of commands is required to make sure that each peer will proxy-route for 20 seconds?
Options
- ADellSwitch1(config)#vlt-domain 100 DellSwitch1(config-vpo)#peer-gateway DellSwitch1(config-vlt-domain)#peer-timeout 20
- BDellSwitch1(config)#vlt-domain 100 DellSwitch1(config-vlt-domain)#peer-routing DellSwitch1(config-vlt-domain)#peer-routing-timeout 20
- CDellSwitch1(config)#vlt-domain 100 DellSwitch1(config-vlt-domain)#peer-proxy DellSwitch1(config-vlt-domain)#peer-proxy-route 20000
- DDellSwitch1(config)#router ospf 10 DellSwitch1(config-router)#proxy-route DellSwitch1(config-ospf-10)#vlt timing 20
How the community answered
(51 responses)- A10% (5)
- B82% (42)
- C2% (1)
- D6% (3)
Community Discussion
No community discussion yet for this question.