DES-5121 Exam Questions
73 real DES-5121 exam questions with expert-verified answers and explanations. Page 2 of 2.
- Question #51
A network administrator has reported poor network performance to an application server. After reviewing the logs, you determine that the server is using 100 percent of the availabl...
- Question #52
What is recommended configuration for an MLAG peer-link on a Dell EMC N-Series switch?
- Question #53
Which type of an attack is considered network poisoning?
- Question #54
Based on the exhibit, why is only one link active?
- Question #55
VOIP traffic needs multiple QoS prioritization schemes, what refers to VoIP traffic?
- Question #56
In order to create a packet's routing direction, which packet layers can policy-based routing use?
- Question #57
A network administrator wants to configure an ACL to deny traffic for a specific source IP and source UDP port. Which type of ACL should be used?
- Question #58
How does weighted Queue Scheduler prioritize packets?
- Question #59
Which of the characteristics can policy-based routing be configured to match against?
- Question #60
Which spanning tree feature will prevent unnecessary timeouts from DHCP servers?
- Question #61
Based on the exhibit, Which authentication method will be used if a user tries to log into the switch when accessing through SSH?
- Question #62
Based on the exhibit, which configuration on interface G1/0/18 will allow the DHCP request to reach the DHCP server for the specified VLAN?
- Question #63
How many untagged VLANs are allowed on a switchport mode trunk interface?
- Question #64
Match the DSCP class selectors with their description.
- Question #65
What is the typical sequence of steps to upgrade the firmware of a Dell EMC N-Series switch?
- Question #66
How many ACLs are supported on a single interface in Dell EMC switches?
- Question #67
In a design of three-tier hierarchical campus network, what are connected at the Access layer?
- Question #68
When using LLDP for configuration communication, what additional protocol features should be enabled to allow the switch to share all VoIP related parameters?
- Question #69
What decimal value is used to indicate Assured Forwarding when implementing DSCP prioritization?
- Question #70
Which decimal value is commonly used to indicate video traffic when implementing COS prioritization?
- Question #71
Which command will show the policy-based routing map applied on an interface?
- Question #72
What is the first of 640 Gbps fabric capacity and hot swap expansion module support for dual QSFP+ (8 x 10GbE)
- Question #73
Which statement represents a topology with all Dell EMC N4000 Series switches with RSTP enabled. In addition, the switches are using the default configuration on all ports and prot...