DES-5121 Exam Questions
73 real DES-5121 exam questions with expert-verified answers and explanations. Page 1 of 2.
- Question #1
When a VRRP Master router is rebooted, what is the default behavior once it comes back online?
- Question #2
Two groups of routers are running VRRP with a virtual router ID of 155, which MAC address will be used to respond to the ARP requests for the virtual IP?
- Question #3
An administrator just finished configuring a Dell EMC N-Series switch. After rebooting the switch, the administrator notices that all the configuration settings just entered are go...
- Question #4
When configuring a PBR route-map, what are the configurable "SET" options?
- Question #5
A user's host with an IP address of 172.16.1.22/24 is attempting to FTP a file from the server with IP address 10.1.1.99; however, they are unable to connect. Which access-list is...
- Question #6
When setting up VoIP, you decide that you want to use LLDP. LLDP is enabled by default and LLDP Transmit Management Information and Notification modes are enabled. What additional...
- Question #7
After setting up the VoIP configuration, a network administrator issues the following commands with the results shown: console# show voice vlan Voice VLAN Status......................
- Question #8
What is the IP protocol number, in decimal, assigned by IANA for VRRP?
- Question #9
What is the recommended maximum number of routers, per area, when using OSPF?
- Question #10
Refer to the Exhibit. If Client B sends a packet to Client A, what is the highest level of the network hierarchy that the packet will transverse?
- Question #11
When configuring a Dell EMC N-Series switch for voice traffic, which settings are needed?
- Question #12
What is the interaction between CDP, ISDP, and LLDP when communicating configuration information from a Dell EMC Campus networking switch to a Cisco VoIP phone?
- Question #13
A network administrator is troubleshooting why Host 1 cannot communicate with Host 2. Based on the switch output shown in the exhibit, what is the reason for the communication issu...
- Question #14
What are the key features of the Dell EMC N4064 or N4064F switches?
- Question #15
An administration has an IP phone connected to a Dell EMC N-Series switch. What is the recommended number of VLANs that should be configured on the switch port?
- Question #16
Refer to the exhibit. A network administrator has created an ACL to block broadcast traffic to their server on port Gi1/0/1. Why is the ACL not functioning as desired?
- Question #17
A user's workstation is connected to an IP phone that is connected to a Dell EMC N-Series switch. Which type of traffic is typically tagged or untagged?
- Question #18
What happens when a match is found for an ACL with 15 entries?
- Question #19
Which interface on a Dell EMC N-Series switch provides the most security for management?
- Question #20
When configuring a Dell EMC N-Series switch for VoIP and QoS, what is one QoS setting that ensures voice traffic is prioritized in the presence of other network traffic?
- Question #21
A customer is upgrading their campus network Access layer switches. They require 2-10GbE uplinks, 48- 1GbE ports with PoE, and stacking capability of up to 12 units. Which Dell EMC...
- Question #22
You are tasked with deploying a single Dell EMC N-Series switch with a 2-port port-channel to uplink to an existing upstream switch. The following reflects the current port-channel...
- Question #23
An existing interface has been properly configured for static port security with one defined allowable MAC address. However, when the network administrator plugs a switch into that...
- Question #24
In a traditional campus network design using a three-tier hierarchical model, what are the key attributes of the Core layer in this model?
- Question #25
Which default security level can be assigned to limit access of a specific user to a Dell EMC N-Series switch?
- Question #26
Which ports on a spanning tree root switch are always forwarding?
- Question #27
To which destination MAC address are MLAG peer-keepalive packets sent?
- Question #28
You need to configure OSPF on a DNOS 6 switch and have entered the following: Switch-1(config)# ip routing Switch-1(config)# interface vlan 20 Switch-1(config-if)# ip address 10.1....
- Question #29
A network administrator is setting up several stacks in their network that includes different Dell EMC N-Series models. Which N-Series switch models require mini-SAS stacking cable...
- Question #30
A network administrator added a new Dell EMC N-Series switch into their network with RSTP configured. The spanning-tree priority on all existing switches has been left at the defau...
- Question #31
A network administrator has configured a 4-port port-channel between two Dell EMC Campus networking switches. The physical interfaces show as administratively up and operationally...
- Question #32
What describes the PoE+ capabilities of the Dell EMC N1100P Series?
- Question #33
Which port security method converts existing dynamically learned MAC addresses on an interface to this mode and not age out?
- Question #34
Refer to the Exhibit. A network administrator needs to configure the switches to allow traffic to communicate from Host 1 to Host 2. Which recommended switch port mode should the i...
- Question #35
Two switches are part of the same VRRP group with the following priorities configured: Switch1: Priority 110 Switch2: Priority 90 Switch2 is required to be the Master if interface...
- Question #36
Which technologies can be implemented when configuring policy-based routing?
- Question #37
A network has three switches with the following IP addresses: Switch1: 192.168.1.240 Switch2: 192.168.1.241 The administrator wants to add VRRP on an existing switch configuration...
- Question #38
Which STP-PV features are embedded and cannot be disabled?
- Question #39
A Master switch failed in a Dell EMC N-Series three-unit switch stack and the Standby switch assumed the role of Master. What happens when the failed Master switch rejoins the stac...
- Question #40
What is the maximum number of dynamic MAC addresses that can be learned on a Dell EMC N-Series switchport that is configured for dynamic locking?
- Question #41
A network administrator is setting up a Class 5 powered device in their network. Which Dell EMC N-Series switch mode(s) will support this device?
- Question #42
Which switchport mode is recommended for ports on a Dell EMC N-Series switch with IP phones using voice VLAN?
- Question #43
Which AAA method is only used for 802.1x and never returns an error?
- Question #44
Which Layer 3 protocol does MLAG support?
- Question #45
In a PoE environment, what information does the Network Policy TLV exchange between the PSE and PD?
- Question #46
Which function does a VRRP backup router perform?
- Question #47
Which command(s) should a network administrator use to configure a RADIUS server on a Dell EMC N- Series switch?
- Question #48
A network administrator is planning a PoE budget for their network. What is the PoE source maximum power budget for a Class 4 end device?
- Question #49
A Dell EMC N-Series switch is configured to uplink to a customer switch using two separate 4-port port-channels configured as trunks. Both switches are configured with 10 VLANs and...
- Question #50
N4032F#show interfaces status Port Description Duplex Speed Neg Link State Flow Ctrl Up Up Off Up Te1/0/5 Full 1000 Auto Up Up Off A Te1/0/6 Full 1000 Auto Up Up Off A VLAN 1 1 1 N...