An MX7000 administrator has been tasked to perform the initial configuration of a new MX platform. The MX700 has seven MX740c, one MX5016s, two Management Modules (MMs), an LED-Only control panel…

Question

Options

• AUse a serial DB9 / DB cable
• BUse KVM and racadm setniccfg command from MM configuration menu
• CUse Ethernet front panel port default DHCP address
• DUse QuickSync 2

• A
  10% (2)
• B
  80% (16)
• C
  5% (1)
• D
  5% (1)

Explanation

Option B is correct because the MX7000 Management Module (MM) is the primary management controller for the chassis, and its configuration menu is accessed via a KVM connection - from there, the racadm setniccfg command is the Dell-documented method to assign network settings to the MM so it can be reached over the network for further management. Option A is wrong because the MX7000 MM uses a micro-USB serial connector, not a legacy DB9 serial cable. Option C is invalid because while the MM management port can receive a DHCP address, you have no reliable way to discover that dynamically-assigned IP during initial setup without prior network configuration - there is no "front panel Ethernet port" in the traditional sense. Option D is wrong because QuickSync 2 is a feature found on individual Dell PowerEdge servers for mobile out-of-band configuration, not on the MX7000 chassis MM.

Memory tip: Think "MM = Main Method" - for any MX7000 initial config question, the Management Module accessed via KVM is your starting point, and setniccfg is how you give it an identity on the network.

No community discussion yet for this question.