D-NWG-FN-23 Exam Questions

What is the FCS field used for in an Ethernet frame?

What is the size of the ICMP header?

Which two port states are valid on a root bridge in a converged Spanning Tree network? (Choose two.)

A network technician has printers that negotiate at half-duplex. Which three switches will auto- negotiate the printers? (Choose three.)

What are three benefits of using dynamic routing protocols over static routing? (Choose three.)

Refer to the output shown: Which two statements describe the state of configuration of interfaces gi1/0/1-24? (Choose two.)

Two N3024F switches are directly connected using 10GBASE-SR transceivers and 10 foot fiber patch cables. The ports on both sides are NOT linking. What are two possible reasons for...

What accurately describes an ICMP error message?

What is the default OSPF "hello interval"?

A network administrator wants to use a subnet that will only have two host addresses. Which subnet mask meets this requirement?

Which platforms are supported by the Dell EMC Networking OS (DNOS) 6?

Which switch should Spanning Tree Protocol choose to become the root bridge in the election process?

In addition to receiving an IP address, what other information is obtained from a DHCP server?

Which IP address belongs to the same subnet as 192.168.8.10/22?

What is the dotted decimal notation for a /29 prefix?

What is the maximum frequency of a CAT6 UTP cable?

When configuring a switch, which CLI mode only supports limited show commands?

Which command sequence leads to the successful creation of a Layer 3 port channel on an OS10 switch?

Which type of route is often used to direct traffic bound for the Internet?

How is a switch different from a hub?

Which IEEE standard defines the Data Link Layer, Discovery protocol?

What does the blinking yellow Activity/PoE LED indicate on an N-Series switch?

On which Dell EMC Networking switches can Multi-Chassis Link Aggregation (MLAG) be configured?

A Dell EMC Networking N-Series switch is configured on a port channel with LACP using the interfaces Te1/0/1 and Te1/0/2. How is the egress traffic distributed among the interfaces...

Which IPv6 scope is used for private addressing within an organization?

Which Border Gateway Protocol (BGP) version supports IPv6?

Which IPv6 address type is similar to IPv4 APIPA?